My D-link USB DUB-E100 adapter seems to work only for a while on recent and older 5.1-CURRENT. After that it seems to lose sight of it's PHY; Also on boots it complains about MII without any PHY! randomly, pulling and re-plugging it will eventually get it running and it works for 5-10 minutes after failing again. This happens on two different desktops and IBM X31 thinkpad I've tried so far. (all running current, oldest is about 1.5mo old, most recent two days old) It's also curious that the LINK led does not work on the adapter. axe0: read PHY failed axe0: read PHY failed axe0: read PHY failed axe0: read PHY failed axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: usb error on rx: IOERROR axe0: at uhub0 port 1 (addr 2) disconnected bmtphy0: detached miibus0: detached axe0: detached axe0: D-Link 10/100 ethernet adapter, rev 2.00/0.01, addr 2 axe0: Ethernet address: 00:40:05:90:95:5d axe0: MII without any PHY! device_probe_and_attach: axe0 attach returned 6 ugen0: D-Link 10/100 ethernet adapter, rev 2.00/0.01, addr 2 ugen0: at uhub0 port 1 (addr 2) disconnected ugen0: detached axe0: D-Link 10/100 ethernet adapter, rev 2.00/0.01, addr 2 axe0: Ethernet address: 00:40:05:90:95:5d miibus0: <MII bus> on axe0 bmtphy0: <BCM5221 10/100baseTX PHY> on miibus0 bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto PeteReceived on Thu Aug 21 2003 - 07:25:08 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:19 UTC