On Sat, Aug 30, 2003 at 11:33:17AM +0100, Matt wrote: > Hi, > > I now have a new issue with ATAng that I didn't have last week when I tried > ATAng. My CDRW is now not detected during probing. I get this message: > > Aug 30 11:21:00 neo kernel: ad0: 76319MB <ST380020A> [155061/16/63] at > ata0-master UDMA100 > Aug 30 11:21:00 neo kernel: ata1-slave: FAILURE - ATA_IDENTIFY > status=41<READY,ERROR> error=4<ABORTED> > Aug 30 11:21:00 neo kernel: acd0: DVDROM <Compaq DVD-ROM SD-616T> at > ata1-master PIO4 I have something roughly the same. It started right away with ATAng in my case: : atapci0: <VIA 82C686A UDMA66 controller> port 0xd000-0xd00f at device 7.1 on pci0 ata0: pre reset mask=03 ostat0=50 ostat2=00 ata0-master: ATAPI 00 00 ata0-slave: ATAPI 00 00 ata0: after reset mask=03 stat0=50 stat1=00 ata0-master: ATA 01 a5 ata0: devices=01 ata0: at 0x1f0 irq 14 on atapci0 ata1: pre reset mask=03 ostat0=50 ostat2=50 ata1-slave: ATAPI 14 eb ata1-master: ATAPI 00 00 ata1: after reset mask=03 stat0=00 stat1=00 ata1-master: ATA 01 a5 ata1: devices=09 ata1: at 0x170 irq 15 on atapci0 : ata0-master: pio=0x0c wdma=0x22 udma=0x44 cable=80pin ad0: setting UDMA66 on VIA 82C686A chip ad0: <WDC WD205BA/16.13M16> ATA-4 disk at ata0-master ad0: 19574MB (40088160 sectors), 39770 C, 16 H, 63 S, 512 B ad0: 16 secs/int, 1 depth queue, UDMA66 GEOM: new disk ad0 ata1-slave: pio=0x0c wdma=0x22 udma=0xffffffff cable=40pin ata1-master: FAILURE - ATA_IDENTIFY status=51<READY,DSC,ERROR> error=4<ABORTED> acd0: setting PIO4 on VIA 82C686A chip acd0: <LG CD-RW CED-8083B/1.06> CDRW drive at ata1 as slave acd0: read 4134KB/s (5512KB/s) write 689KB/s (689KB/s), 2048KB buffer, PIO4 acd0: Reads: CDR, CDRW, CDDA stream, packet acd0: Writes: CDR, CDRW, test write acd0: Audio: play, 255 volume levels acd0: Mechanism: ejectable tray, unlocked acd0: Medium: no/blank disc : Some roughly 90% of the time the CDRW is probed and the DVD is not, but it accassionally is the other way around. If I run atacontrol(8) often enough I get this: Aug 29 22:24:10 athlon sudo: marcel : TTY=ttyp0 ; PWD=/home/marcel ; USER=root ; COMMAND=/sbin/atacontrol reinit 1 Aug 29 22:24:10 athlon kernel: ata1: resetting devices .. Aug 29 22:24:10 athlon kernel: ata1-master: FAILURE - ATA_IDENTIFY status=51<READY,DSC,ERROR> error=4<ABORTED> Aug 29 22:24:10 athlon kernel: done : (10 minutes worth of atacontrol :-) : Aug 29 22:24:43 athlon sudo: marcel : TTY=ttyp0 ; PWD=/home/marcel ; USER=root ; COMMAND=/sbin/atacontrol reinit 1 Aug 29 22:24:43 athlon kernel: ata1: resetting devices .. Aug 29 22:24:43 athlon kernel: acd0: WARNING - removed from configuration Aug 29 22:24:43 athlon kernel: ata1-slave: FAILURE - ATA_IDENTIFY status=51<READY,DSC,ERROR> error=4<ABORTED> Aug 29 22:24:43 athlon kernel: acd0: DVDROM <SAMSUNG DVD-ROM SD-608> at ata1-master PIO4 Aug 29 22:24:43 athlon kernel: done Both drives function without problems when they are probed. I wanted to collect more data before sending out mail, but seeing your mail, I might as well chime in now :-) FYI, -- Marcel Moolenaar USPA: A-39004 marcel_at_xcllnt.netReceived on Sat Aug 30 2003 - 09:11:46 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:20 UTC