Please test this patch, hopefully it improves the "short cable" situation on FreeBSD-current. Poul-Henning Index: if_sis.c =================================================================== RCS file: /home/ncvs/src/sys/pci/if_sis.c,v retrieving revision 1.90 diff -u -r1.90 if_sis.c --- if_sis.c 14 Nov 2003 19:00:31 -0000 1.90 +++ if_sis.c 2 Dec 2003 11:27:10 -0000 _at__at_ -2095,6 +2095,28 _at__at_ sis_list_tx_init(sc); /* + * Page 78 of the DP83815 data sheet (september 2002 version) + * recommends the following register settings "for optimum + * performance." for rev 15C. The driver from NS also sets + * the PHY_CR register for later versions. + */ + if (sc->sis_type == SIS_TYPE_83815) { + CSR_WRITE_4(sc, NS_PHY_PAGE, 0x0001); + /* DC speed = 01 */ + CSR_WRITE_4(sc, NS_PHY_CR, 0x189C); + if (sc->sis_srr == NS_SRR_15C) { + /* set val for c2 */ + CSR_WRITE_4(sc, NS_PHY_TDATA, 0x0000); + /* load/kill c2 */ + CSR_WRITE_4(sc, NS_PHY_DSPCFG, 0x5040); + /* rais SD off, from 4 to c */ + CSR_WRITE_4(sc, NS_PHY_SDCFG, 0x008C); + } + CSR_WRITE_4(sc, NS_PHY_PAGE, 0); + } + + + /* * For the NatSemi chip, we have to explicitly enable the * reception of ARP frames, as well as turn on the 'perfect * match' filter where we store the station address, otherwise _at__at_ -2148,7 +2170,6 _at__at_ CSR_WRITE_4(sc, SIS_RX_CFG, SIS_RXCFG256); } - /* Accept Long Packets for VLAN support */ SIS_SETBIT(sc, SIS_RX_CFG, SIS_RXCFG_RX_JABBER); _at__at_ -2183,12 +2204,15 _at__at_ CSR_WRITE_4(sc, NS_PHY_PAGE, 0x0001); reg = CSR_READ_4(sc, NS_PHY_DSPCFG); + /* Allow coefficient to be read */ CSR_WRITE_4(sc, NS_PHY_DSPCFG, (reg & 0xfff) | 0x1000); DELAY(100); reg = CSR_READ_4(sc, NS_PHY_TDATA); - if ((reg & 0x0080) == 0 || (reg & 0xff) >= 0xd8) { + if ((reg & 0x0080) == 0 || + (reg > 0xd8 && reg <= 0xff)) { device_printf(sc->sis_self, "Applying short cable fix (reg=%x)\n", reg); CSR_WRITE_4(sc, NS_PHY_TDATA, 0x00e8); + /* Adjust coefficient and prevent change */ SIS_SETBIT(sc, NS_PHY_DSPCFG, 0x20); } CSR_WRITE_4(sc, NS_PHY_PAGE, 0); _at__at_ -2216,21 +2240,6 _at__at_ #ifdef notdef mii_mediachg(mii); #endif - - /* - * Page 75 of the DP83815 manual recommends the - * following register settings "for optimum - * performance." Note however that at least three - * of the registers are listed as "reserved" in - * the register map, so who knows what they do. - */ - if (sc->sis_type == SIS_TYPE_83815) { - CSR_WRITE_4(sc, NS_PHY_PAGE, 0x0001); - CSR_WRITE_4(sc, NS_PHY_CR, 0x189C); - CSR_WRITE_4(sc, NS_PHY_TDATA, 0x0000); - CSR_WRITE_4(sc, NS_PHY_DSPCFG, 0x5040); - CSR_WRITE_4(sc, NS_PHY_SDCFG, 0x008C); - } ifp->if_flags |= IFF_RUNNING; ifp->if_flags &= ~IFF_OACTIVE; -- Poul-Henning Kamp | UNIX since Zilog Zeus 3.20 phk_at_FreeBSD.ORG | TCP/IP since RFC 956 FreeBSD committer | BSD since 4.3-tahoe Never attribute to malice what can adequately be explained by incompetence.Received on Tue Dec 02 2003 - 04:26:17 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:32 UTC