On Tue, 9 Dec 2003, Harald Schmalzbauer wrote: > I just rebooted into 5.2-RC and found that I still get these messages when I > plug in my USB Flash-Adaptor: (aren't these debug messages?) > Everything's working fine so far. > > umass0: Generic USB Storage Device, rev 1.10/1.00, addr 5 > GEOM: create disk da0 dp=0xc2d61050 > da0 at umass-sim0 bus 0 target 0 lun 0 > da0: <Generic USB Storage-SMC 0180> Removable Direct Access SCSI-0 device > da0: 1.000MB/s transfers > da0: Attempt to query device size failed: NOT READY, Medium not present > (da0:umass-sim0:0:0:0): READ CAPACITY. CDB: 25 0 0 0 0 0 0 0 0 0 > (da0:umass-sim0:0:0:0): CAM Status: SCSI Status Error > (da0:umass-sim0:0:0:0): SCSI Status: Check Condition > (da0:umass-sim0:0:0:0): NOT READY asc:3a,0 > (da0:umass-sim0:0:0:0): Medium not present ^^^^^^^^^^^^^^^^^^ These messages are displayed for diagnostic purposes in the unlikely event that a user's flashcard reader would cause problems. The da0:umass-* messages are indicating that there are no flashcards plugged in at this point of time. If you have the slots filled when you plug in the device or while the system starts up, you won't see these messages. Regards, > Andre Guibert de Bruet | Enterprise Software Consultant > > Silicon Landmark, LLC. | http://siliconlandmark.com/ >Received on Tue Dec 09 2003 - 00:30:27 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:33 UTC