RE: panic: probing for non-PCI bus

On 10-Nov-2003 John Hay wrote:
> Hi,
> 
> Upgrading a Asus P2L97-DS dual Pentium II 266MHz box, I got this panic
> when booting:
> 
>############################
> Console: serial port
> BIOS drive A: is disk0
> BIOS drive C: is disk1
> BIOS drive D: is disk2
> BIOS drive E: is disk3
> BIOS 640kB/130036kB available memory
> 
> FreeBSD/i386 bootstrap loader, Revision 1.1
> (jhay_at_beast.icomtek.csir.co.za, Sun Nov  2 14:16:55 SAST 2003)
> Loading /boot/defaults/loader.conf 
> /boot/kernel/kernel text=0x23372c data=0x27fcc+0x47494 syms=[0x4+0x31690+0x4+0x3de08]
> /boot/kernel/if_vlan.ko text=0x22b0 data=0x1d8+0x5c syms=[0x4+0x620+0x4+0x573]
> /boot/kernel/if_fxp.ko text=0x77c0 data=0xfd4+0xc syms=[0x4+0xc50+0x4+0xceb]
> loading required module 'miibus'
> /boot/kernel/miibus.ko text=0x15940 data=0xc84+0x68 syms=[0x4+0x1a90+0x4+0x2240]
> /boot/kernel/usb.ko text=0x201e8 data=0xb4c+0x148 syms=[0x4+0x2ad0+0x4+0x30bb]
> 
> Hit [Enter] to boot immediately, or any other key for command prompt.
> Booting [/boot/kernel/kernel]...               
> Copyright (c) 1992-2003 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>         The Regents of the University of California. All rights reserved.
> FreeBSD 5.1-CURRENT #50: Mon Nov 10 17:51:13 SAST 2003
>     jhay_at_beast.icomtek.csir.co.za:/b/src/sys/i386/compile/BEAST
> Preloaded elf kernel "/boot/kernel/kernel" at 0xc0768000.
> Preloaded elf module "/boot/kernel/if_vlan.ko" at 0xc076821c.
> Preloaded elf module "/boot/kernel/if_fxp.ko" at 0xc07682c8.
> Preloaded elf module "/boot/kernel/miibus.ko" at 0xc0768374.
> Preloaded elf module "/boot/kernel/usb.ko" at 0xc0768420.
> Timecounter "i8254" frequency 1193182 Hz quality 0
> CPU: Pentium II/Pentium II Xeon/Celeron (267.27-MHz 686-class CPU)
>   Origin = "GenuineIntel"  Id = 0x633  Stepping = 3
>   Features=0x80fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,MMX>
> real memory  = 134205440 (127 MB)
> avail memory = 125018112 (119 MB)
> MPTable: <OEM00000 PROD00000000>
> FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
>  cpu0 (BSP): APIC ID:  1
>  cpu1 (AP): APIC ID:  0
> ioapic0: Assuming intbase of 0
> ioapic0 <Version 1.1> irqs 0-23 on motherboard
> Pentium Pro MTRR support enabled
> acpi0: <ASUS   P2L97-DS> on motherboard
> pcibios: BIOS version 2.10
> Using $PIR table, 7 entries at 0xc00f0d20
> acpi0: Power Button (fixed)
> Timecounter "ACPI-safe" frequency 3579545 Hz quality 1000
> acpi_timer0: <24-bit timer at 3.579545MHz> port 0xe408-0xe40b on acpi0
> acpi_cpu0: <CPU> on acpi0
> pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
> pci0: <ACPI PCI bus> on pcib0
> pcib0: slot 4 INTD is routed to irq 5
> pcib0: slot 6 INTA is routed to irq 5
> pcib0: slot 10 INTA is routed to irq 12
> pcib0: slot 11 INTA is routed to irq 10
> pcib0: slot 12 INTA is routed to irq 11
> panic: probing for non-PCI bus
> cpuid = 0; 
> Uptime: 1s
> Shutting down ACPI
> Automatic reboot in 15 seconds - press a key on the console to abort
> Rebooting...
>############################

Can you provide a copy of your mptable?

-- 

John Baldwin <jhb_at_FreeBSD.org>  <><  http://www.FreeBSD.org/~jhb/
"Power Users Use the Power to Serve!"  -  http://www.FreeBSD.org/