Re: panic: probing for non-PCI bus

Oops, I missed a not.

On Wed, Nov 12, 2003 at 09:01:25AM +0200, John Hay wrote:
> > > Hmmm, I'll have to open it up to see if it has an AGP slot, but it is in
> > > the server room at work. :-/ Here is a dmesg with a kernel of about Nov 3.
> > > 
> > > pcib1: <PCI-PCI bridge> at device 1.0 on pci0
> > > pci1: <PCI bus> on pcib1
> > 
> > Ok, no AGP bus, but you do have a PCI bus that the MP Table doesn't know about.
> > I'll commit a fix.  Note that your system isn't going to work with ACPI.  Perhaps
> > there is a BIOS option to set the interrupt model to APIC rather than PIC that
> > might fix the ACPI case.
> 
> Ok, I opened the machine this morning and it does have an AGP slot.
> 
> I also had a look in the BIOS setup, but didn't see anything to change
> the interrupt model. The closest I saw was:
> 
> MPS 1.4 Support - Enabled/Disabled (Enabled)
> PCI 2.1 Support - Enabled/disabled (Enabled)
> PNP OS Installed - No/Yes (No)
> 
> I built a new kernel with your mptable changes included and with acpi
> enabled, it would panic, but the onboard scsi interrupt doesn't work,
                  ^^^ not
> so you don't get very far. With acpi disabled, it seems to work fine,
> although I haven't done much yet. So it looks like I'm up and running
> again, thanks.

John
-- 
John Hay -- John.Hay_at_icomtek.csir.co.za / jhay_at_FreeBSD.org