On Wed, 2003-11-26 at 13:28, Soren Schmidt wrote: > It seems Joe Marcus Clarke wrote: > > atapci1: <SiI 3112 SATA150 controller> port > > 0x14b0-0x14bf,0x14c0-0x14c3,0x14c8-0x14cf,0x14c4-0x14c7,0x14d0-0x14d7 > > mem 0xe800a000-0xe800a1ff irq 9 at device 16.0 on pci0 > > GEOM: create disk ad4 dp=0xc5246460 > > ad4: 78167MB <Maxtor 6Y080M0> [158816/16/63] at ata2-master UDMA133 > > > > Nothing else was changed in the machine except the specific version of > > -CURRENT since the time things worked and now. In addition to replacing > > the drive, I have replaced the SATA cable as well. My plan is to revert > > the ATA drivers to two weeks ago, and see if the problem persists. > > Failing that, I will test to see if this is a cooling problem. Failing > > that, I will replace the SATA controller. However, I wanted to know if > > I'm barking up the wrong tree, and perhaps this is a software issue. > > There are some early issues of the SiI3112 chips that has problems that > can cause datacorruption etc etc.. > You can try the following patch (which btw re_at_ has for approval), > otherwise I'd try another controller as there seem to be no end of the > troubles with the Sii 3112 chips (brings back to mind the horror times > from when they where called CMD and did the CMD640 disaster)... Thanks, but this patch immediately causes an Input/Output error trying to do a large rm. A few seconds later, and the machine is locked up (probably spewing the same DMA timeouts, but I won't be able to check until I get back home). Joe [ATA patch elided] -- PGP Key : http://www.marcuscom.com/pgp.asc
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:31 UTC