Re: Western Digital WD360GD SATA disk on -CURRENT

From: Derek Ragona <derek_at_computinginnovations.com>
Date: Sun, 30 Nov 2003 01:07:30 -0600
I have a server that uses the same chipset with a maxtor drive, no RAID 
just a single drive.  My hardware exact hardware is:
Adaptec SATA 1210SA (SiI 3112 SATA150 controller in non RAID mode with a 
single drive) and a Maxtor 6Y120M0 120 GB drive

It is probed correctly with the ISO mini 5.2 beta, but it was still having 
data problems with larger IO in multiuser.  The error I get is:

ad4: timeout sending command=ca
ad4: error issuing DMA command

I will try the 11/29 snapshot and see if that is any better.

         -Derek


At 10:56 PM 11/29/2003, Will Andrews wrote:
>Hi,
>
>Ever since I found the set of commits which broke probing this
>disk on/about September 1, I have attempted to boot a JPSNAP
>about once a week.  Up to this day, on which I tried 5.2-BETA
>(official ISO), it has never again probed this drive correctly.
>
>I'm using it with a:
>
>atapci1_at_pci2:6:0:       class=0x018000 card=0x31121095 chip=0x31121095 
>rev=0x02 hdr=0x00
>     vendor   = 'Silicon Image Inc (Was: CMD Technology Inc)'
>     device   = 'SiI 3112 SATARaid Controller'
>     class    = mass storage
>
>(note, no RAID has been configured, only one disk is attached)
>
>Has anyone had better luck?  Thanks.
>
>Regards,
>--
>wca
>_______________________________________________
>freebsd-current_at_freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-current
>To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"
Received on Sat Nov 29 2003 - 22:07:37 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:31 UTC