On Sun, Oct 05, 2003 at 01:55:43AM +0300, Dan Naumov wrote: > On Sun, 2003-10-05 at 00:44, Bernd Walter wrote: > > You need to have intpm hardware to get this driver working. > > There are other drivers available depending on your chipset. > > What is the pciconf -lv output? > > There you go: > > ==================================================== > none0_at_pci0:7:4: class=0x0c0500 card=0x30571106 chip=0x30571106 rev=0x40 > hdr=0x00 > vendor = 'VIA Technologies Inc' > device = 'VT82C686A/B ACPI Power Management Controller' > class = serial bus > subclass = SMBus > > > > Investingating further, I see that I have no "/dev/smb" on my system > > > even though I have "device smb" in my kernel config. I've also noticed a > > > line saying "pci0: <serial bus, SMBus> at device 7.4 (no driver > > > attached)" in my dmesg. > > > > So it's no intpm hardware. > > What drivers should I be using then ? I had lm_sensors on Linux work > with this hardware... With a driver for the hardware it's possible of course. You have a VT82C686A/B chip for which you want viapm driver. intpm is for Intel PIIX4 (82371AB, 82443MX) which you don't have. -- B.Walter BWCT http://www.bwct.de ticso_at_bwct.de info_at_bwct.deReceived on Sat Oct 04 2003 - 14:53:31 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:24 UTC