Hello all, in a precedent message, i reported an error using a flashkey. I must add the following: as one can see in the dmesg below, the controller is NOT the ohci but uhci. The error occurs on writing not reading I tested the file written to the flashkey, without fsync and after unmount applied; The file looks garbage. In this case, as suggested by John-Mark Gurney, the fsync made the trick. Best regards. uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xbce0-0xbcff irq 11 at device 31.2 on pci0 usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhub1: Philips Semiconductors hub, class 9/0, rev 1.10/1.10, addr 2 uhub1: 4 ports with 4 removable, self powered umass0: GENERIC USB Mass Storage, rev 1.10/1.00, addr 3 GEOM: create disk da2 dp=0xc2714c50 da2 at umass-sim0 bus 0 target 0 lun 0 da2: <EasyDisk 1.00> Removable Direct Access SCSI-2 device da2: 1.000MB/s transfers da2: 1000MB (2048000 512 byte sectors: 64H 32S/T 1000C)Received on Sun Sep 07 2003 - 18:59:09 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:21 UTC