backing off to ata-lowlevel.c 1.10 allows me to boot again. --On Saturday, September 13, 2003 18:54:18 -0500 Larry Rosenman <ler_at_lerctr.org> wrote: > > > --On Saturday, September 13, 2003 18:09:21 -0500 Larry Rosenman > <ler_at_lerctr.org> wrote: > >> I have a ICH3 controller, and a 9/9 kernel works just fine, but a today >> kernel >> hangs(!) after printing >> ata0: [MPSAFE] >> >> Here is the GOOD dmesg: >> $ dmesg|grep ata >> atapci0: <Intel ICH3 UDMA100 controller> port >> 0x1c20-0x1c2f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 mem >> 0xe0100000-0xe01003ff at device 31.1 on pci0 >> ata0: at 0x1f0 irq 14 on atapci0 >> ata0: [MPSAFE] >> ata1: at 0x170 irq 15 on atapci0 >> ata1: [MPSAFE] >> ad0: 57231MB <FUJITSU MHS2060AT> [116280/16/63] at ata0-master UDMA100 >> acd0: CDRW <SONY CD-RW CRX800E> at ata1-master WDMA2 >> cd0 at ata1 bus 0 target 0 lun 0 >> $ >> >> Any ideas? >> >> LER > > For the record, I also pulled atapicam out of the kernel, and the same > thing happens. > > Where to, folks? -- Larry Rosenman http://www.lerctr.org/~ler Phone: +1 972-414-9812 E-Mail: ler_at_lerctr.org US Mail: 1905 Steamboat Springs Drive, Garland, TX 75044-6749
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:22 UTC