--On Wednesday, September 17, 2003 00:24:06 +0200 Arjan van Leeuwen <avleeuwen_at_piwebs.com> wrote: > On Tuesday 16 September 2003 23:33, Joachim Strömbergson wrote: >> Aloha! >> >> Arjan van Leeuwen wrote: >> > If I start my kernel from september 15, my computer hangs after this >> > message: >> > >> > atapci0: <VIA 82C686B UDMA100 controller> port 0xa400-0xa40f at device >> > 7.1 on pci0 >> > ata0: at 0x1f0 irq 14 on atapci0 >> > ata0: [MPSAFE] >> >> Did you wait a while? I just completed my system update (getting the >> OpenSSH patch in at the same time, thanks sec-team!). After reboot my >> system also stopped at the exact message above. After what felt like >> about a minute, the system continued to boot and is running normally. >> >> Try again and see if it is a real, solid hang, or if it just takes a >> while. >> >> Included is my dmesg. > > Thanks! I guess I'm too impatient these days... Yes, it works after > waiting for about 30 seconds. So a correction, it doesn't hang, it's > just slow when detecting :). same here. LER > > Arjan > > _______________________________________________ > freebsd-current_at_freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" > -- Larry Rosenman http://www.lerctr.org/~ler Phone: +1 972-414-9812 E-Mail: ler_at_lerctr.org US Mail: 1905 Steamboat Springs Drive, Garland, TX 75044-6749
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:22 UTC