Re: Current 8/27/2004, DVD problems

Some follow-up.

Similar to other folks with this problem, the system will boot in
verbose mode.  However, ONLY with no medium.  If medium is present,
it still hangs.  If the tray is empty, it will boot in either DMA or
PIO mode.  And if I then insert a disc, I can read it OK.

Here's the disk probe part of the dmesg from such a boot...

...
ata0-slave: pio=0x0c wdma=0x22 udma=0x45 cable=80pin
ata0-master: pio=0x0c wdma=0x22 udma=0x45 cable=80pin
ata0-master: setting PIO4 on Intel ICH5 chip
ata0-master: setting UDMA100 on Intel ICH5 chip
ata0-slave: setting PIO4 on Intel ICH5 chip
ata0-slave: setting UDMA100 on Intel ICH5 chip
ad0: <WDC WD400BB-00DEA0/05.03E05> ATA-5 disk at ata0-master
ad0: 38166MB (78165360 sectors), 77545 C, 16 H, 63 S, 512 B
ad0: 16 secs/int, 1 depth queue, UDMA100
GEOM: new disk ad0
ar: FreeBSD check1 failed
[0] f:80 typ:165 s(CHS):0/1/1 e(CHS):1023/254/63 s:63 l:78156162
[1] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[2] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[3] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
GEOM: Configure ad0s1, start 32256 length 40015954944 end 40015987199
ad1: <WDC WD2500JB-00EVA0/15.05R15> ATA-6 disk at ata0-slave
ad1: 238475MB (488397168 sectors), 484521 C, 16 H, 63 S, 512 B
ad1: 16 secs/int, 1 depth queue, UDMA100
GEOM: Configure ad0s1a, start 0 length 268435456 end 268435455
GEOM: Configure ad0s1b, start 268435456 length 4250181632 end 4518617087
GEOM: Configure ad0s1c, start 0 length 40015954944 end 40015954943
GEOM: Configure ad0s1d, start 4518617088 length 268435456 end 4787052543
GEOM: Configure ad0s1e, start 4787052544 length 536870912 end 5323923455
GEOM: Configure ad0s1f, start 5323923456 length 268435456 end 5592358911
GEOM: Configure ad0s1g, start 5592358912 length 268435456 end 5860794367
GEOM: Configure ad0s1h, start 5860794368 length 34155160576 end 40015954943
GEOM: new disk ad1
ar: FreeBSD check1 failed
ata1-slave: pio=0x0c wdma=0x22 udma=0x42 cable=40pin
ATAPI_RESET time = 30us
ata1-master: pio=0x0c wdma=0x22 udma=0x45 cable=80pin
ata1-master: setting PIO4 on Intel ICH5 chip
ata1-master: DMA limited to UDMA33, non-ATA66 cable or device
ata1-master: setting UDMA33 on Intel ICH5 chip
ata1-slave: setting PIO4 on Intel ICH5 chip
ata1-slave: setting UDMA33 on Intel ICH5 chip
ad2: <Maxtor 54610H6/JAC61HU0> ATA-6 disk at ata1-master
ad2: 32253MB (66055248 sectors), 65531 C, 16 H, 63 S, 512 B
ad2: 16 secs/int, 1 depth queue, UDMA33
ar: FreeBSD check1 failed
acd0: <_NEC DVD_RW ND-1300A/1.05> DVDR drive at ata1 as slave
acd0: read 6890KB/s (6890KB/s) write 2755KB/s (2755KB/s), 2048KB buffer, UDMA33
acd0: Reads: CDR, CDRW, CDDA stream, DVDROM, DVDR, packet
acd0: Writes: CDR, CDRW, DVDR, test write, burnproof
acd0: Audio: play, 256 volume levels
acd0: Mechanism: ejectable tray, unlocked
acd0: Medium: no/blank disc
pcm0: measured ac97 link rate at 47998 Hz, will use 48000 Hz
[0] f:80 typ:165 s(CHS):0/1/1 e(CHS):168/15/63 s:63 l:488397105
[1] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[2] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[3] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
GEOM: Configure ad1s1, start 32256 length 250059317760 end 250059350015
GEOM: new disk ad2
[0] f:80 typ:165 s(CHS):0/1/1 e(CHS):1023/15/63 s:63 l:66055185
[1] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[2] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
[3] f:00 typ:0 s(CHS):0/0/0 e(CHS):0/0/0 s:0 l:0
GEOM: Configure ad2s1, start 32256 length 33820254720 end 33820286975
GEOM: Configure ad2s1c, start 0 length 33820254720 end 33820254719
GEOM: Configure ad2s1d, start 0 length 5368709120 end 5368709119
GEOM: Configure ad2s1e, start 5368709120 length 28451545600 end 33820254719
(probe0:sbp0:0:0:0): error 22
(probe0:sbp0:0:0:0): Unretryable Error
(probe1:sbp0:0:1:0): error 22
(probe1:sbp0:0:1:0): Unretryable Error
(probe2:sbp0:0:2:0): error 22
(probe2:sbp0:0:2:0): Unretryable Error
(probe3:sbp0:0:3:0): error 22
(probe3:sbp0:0:3:0): Unretryable Error
(probe4:sbp0:0:4:0): error 22
(probe4:sbp0:0:4:0): Unretryable Error
(probe5:sbp0:0:5:0): error 22
(probe5:sbp0:0:5:0): Unretryable Error
(probe6:sbp0:0:6:0): error 22
(probe6:sbp0:0:6:0): Unretryable Error
SMP: AP CPU #1 Launched!
cpu1 AP:
     ID: 0x01000000   VER: 0x00050014 LDR: 0x02000000 DFR: 0x0fffffff
  lint0: 0x00010700 lint1: 0x00010400 TPR: 0x00000000 SVR: 0x000001ff
ioapic0: routing intpin 1 (ISA IRQ 1) to cluster 0
...