Re: 5.2.1-RC2: could not get PCI interrupt routing table for ...

From: John Baldwin <jhb_at_FreeBSD.org>
Date: Mon, 23 Feb 2004 14:53:25 -0500
On Sunday 22 February 2004 12:57 pm, Don Bowman wrote:
> On a supermicro 6033P-8R system
> (http://www.supermicro.com/PRODUCT/SUPERServer/SuperServer6033P-8R.htm)
>
> I'm getting an error on bootup as below:
>
> pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
> pci0: <ACPI PCI bus> on pcib0
> pci0: <unknown> at device 0.1 (no driver attached)
> pcib1: <ACPI PCI-PCI bridge> at device 2.0 on pci0
> pcib1: could not get PCI interrupt routing table for \\_SB_.PCI0.HLB_ -
> AE_NOT_FOUND
>  ...
> pcib4: <ACPI PCI-PCI bridge> at device 3.0 on pci0
> pcib4: could not get PCI interrupt routing table for \\_SB_.PCI0.HLC_ -
> AE_NOT_FOUND
> pci4: <ACPI PCI bus> on pcib4
> pci4: <base peripheral, interrupt controller> at device 28.0 (no driver
> attached)
>
> First question: Do i need to worry? This is from the install CD, i have not
> yet built a kernel.
>
> System is using ASR 2010S zero-channel raid, 6 75GB U320 15KRM disc, 4GB
> memory, 2x 2.8GHz Xeon. In the bios, I set the 'OS Type' to 'Other', should
> i try 'win2k' or something else to make it route interrupts differently?

As long as there are no actual devices on pci1 and pci4 other than pci-pci 
bridges, you are ok.  Your mptable doesn't list any devices on busses 1 and 
4, so you are probably fine.

-- 
John Baldwin <jhb_at_FreeBSD.org>  <><  http://www.FreeBSD.org/~jhb/
"Power Users Use the Power to Serve"  =  http://www.FreeBSD.org
Received on Mon Feb 23 2004 - 11:14:57 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:44 UTC