5.2.1 on Acer Travelmate 800 LCi boot of install CD fails

From: Clint Gilders <techservices_at_onlinehobbyist.com>
Date: Fri, 27 Feb 2004 09:51:32 -0500
This is a 5.2.1 mini install ISO downloaded today.  The Laptop is a 1.3 
Ghz Centrino with 30GB drive, broadcom Ethernet, Intel 2100 Mini PCI 
wlan, 30Gb drive, ATI Mobilty Radeon 9000 graphics.

When I select the default boot:

It goes through much of the hardware detection and freezes at:

Timecounters tick every 10.000 msec
ata0-master: WARNING - ATA_IDENTIFY interrupt was seen but taskqueue 
stalled LBA=0

With ACPI disabled it is much the same with a few more errors before it 
hangs:

unknown: <PNP0303> can't assign resources (port)
unknown: <PNP0f13> can't assign resources (irq)
unknown: <PNP0501> can't assign resources (port)
fdc1: cannot reserve I/O port range (1 ports)
unknown: <PNP0401> can't assign resources (port)
unknown: <HWPc224> can't assign resources (port)
Timecounter "TSC" frequency 1298903370 Hz quality 800
Timecounters tick every 10.000 msec
ata0-master: WARNING - ATA_IDENTIFY interrupt was seen but taskqueue 
stalled LBA=0

In safe mode I get the same errors as above.

With verbose logging I get:

Timecounters tick every 10.000 msec
lo0: bpf attached
ata1: spurious interrupt - status=0x00 error=0x01
Current DB 0
ch = 0
Currnet  OP  KEY INT BR len Addr Depend Stat: Cnt
002c8000 OUTL ST_at_ ALL ALL 12 00000000 002c8080 8411:0008 RUN ACTIVE, ack 
complete(11)
0x000000e0 0x00450000 0xffbaffff 0x00000000
bus_explore done
sbp_post_explore (sbp_cold=2)
ata0-master: WARNING - ATA_IDENTIFY interrupt was seen but taskqueue
stalled LBA=0

Varous Linux Distros work fine on this Laptop, and so does FreeBSD 4.9.

Ideas?  Solutions?  Thoughts?   Any other info I could provide to help 
fix this?

Thanks
-- 
Clint Gilders <techservices_at_onlinehobbyist.com>
Director of Technology Services
OnlineHobbyist.com, Inc.
Received on Fri Feb 27 2004 - 05:51:36 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:44 UTC