On 1/29/2004 6:02 AM, Panagiotis Astithas wrote: > Panagiotis Astithas wrote: >> Lefteris Chatzibarbas wrote: >>> Hello, >>> >>> Devices are: >>> >>> ad0: <WDC WD800JB-00ETA0/77.07W77> ATA-6 disk at ata0-master >>> acd0: <DV-516E/3.04> DVDROM drive at ata1 as master >>> acd1: <CD-W524E/1.0A> CDRW drive at ata1 as slave >>> >>> Verbose boot of a good kernel: >>> >>> http://members.hellug.gr/lefcha/dmesg.out >>> >>> System still hangs during boot with the message: >>> >>> ata1-master: TIMEOUT - SETFEATURES SET TRANSFER MODE retrying (0 >>> retries left) >>> <snip> >>> >>> http://lists.freebsd.org/pipermail/cvs-src/2004-January/016880.html >>> >>> ... didn't correct the problem. >>> >>> Thanks >> >> "Me too". >> Same controller, same hard disk, only one device on the second channel: >> acd0: DVDROM <DVD-ROM DDU1621> at ata1-master UDMA33 >> I used 5.2-RELEASE and the -current snapshot form 24/1. The former >> freezes after the "TIMEOUT" message, the latter just locks up solid. >> The machine runs happily a -current from last October though. > > > I found out that booting with "Safe mode" (I knew there should be some > use for it :-)) allows me to complete the process and get to sysinstall, > in both 5.2-RELEASE & the -current snapshot from 24/1. But I tried to do > the same from the loader prompt, to no avail. I used the following and > then "boot" or "boot -v" but every attempt resulted in the traditional > freeze. > > unset acpi_load > set hint.acpi.0.disabled=1 > set loader.acpi_disabled_by_user=1 > set hw.ata.ata_dma=0 > set hw.ata.atapi_dma=0 > set hw.ata.wc=0 > set hw.eisa_slots=0 > > From what I can tell from the beastie.4th file, that is all that should > be needed. Am I missing something? You missed disabling apic: set hint.apic.0.disabled=1 Jon NoackReceived on Thu Jan 29 2004 - 11:31:21 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:40 UTC