On 2004-06-22 22:06 +0200, Lukas Ertl <le_at_FreeBSD.org> wrote: > Hi, > > I'd like to merge a ulpt(4) patch from NetBSD, but since I don't have a > USB printer I'd be glad if someone out there owning such a piece of > hardware could test it: > > <http://people.freebsd.org/~le/ulpt.diff> The patch doesin't break anything on my system with a PCL compatible laser printer connected via USB: ulpt0: SAMSUNG ELECTRONICS CO., LT Samsung ML-6060 Series, rev 1.10/1.00, addr 2, iclass 7/1 ulpt0: using bi-directional mode The following message lines correspond to switching the printer off and on again (with patch; no change at all to the driver without the patch): ulpt0: at uhub1 port 2 (addr 2) disconnected ulpt0: detached ulpt0: SAMSUNG ELECTRONICS CO., LT Samsung ML-6060 Series, rev 1.10/1.00, addr 2, iclass 7/1 ulpt0: using bi-directional mode Printing works fine (tested from OpenOffice via CUPS/ghostscript/PCL backend). System is an Athlon XP with VIA KT400 chip set: uhci0: <VIA 83C572 USB controller> port 0xa000-0xa01f irq 21 at device 16.0 on pci0 uhci0: [GIANT-LOCKED] usb0: <VIA 83C572 USB controller> on uhci0 usb0: USB revision 1.0 uhci1: <VIA 83C572 USB controller> port 0x9800-0x981f irq 21 at device 16.1 on pci0 uhci1: [GIANT-LOCKED] usb1: <VIA 83C572 USB controller> on uhci1 usb1: USB revision 1.0 uhci2: <VIA 83C572 USB controller> port 0x9400-0x941f irq 21 at device 16.2 on pci0 uhci2: [GIANT-LOCKED] usb2: <VIA 83C572 USB controller> on uhci2 usb2: USB revision 1.0 ehci_pci_attach: companion usb0 ehci_pci_attach: companion usb1 ehci_pci_attach: companion usb2 usb3: EHCI version 1.0 usb3: companion controllers, 2 ports each: usb0 usb1 usb2 usb3: <EHCI (generic) USB 2.0 controller> on ehci0 usb3: USB revision 2.0 Regards, STefanReceived on Wed Jun 23 2004 - 05:16:34 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:58 UTC