Regression in CardBus

From: Kevin Oberman <oberman_at_es.net>
Date: Wed, 24 Mar 2004 13:42:40 -0800
I am running current as of last Saturday (3/13).

On a recent trip I had to dial in to work at the airport. I inserted my
trusty Xircom RBEM56G-100 combo Ethernet/modem card which I have been
using for over a year on current, but have not used for several months.

I get the following messages on insertion:
dc0: <Xircom X3201 10/100BaseTX> port 0x1100-0x117f mem 0x20000000-0x200007ff,0x20000800-0x20000fff irq 11 at device 0.0 on cardbus1
miibus1: <MII bus> on dc0
tdkphy0: <TDK 78Q2120 media interface> on miibus1
tdkphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
dc0: Ethernet address: 00:10:a4:e0:07:4f
sio4: configured irq 11 not in bitmap of probed irqs 0
sio4: port may not be enabled
sio4: configured irq 11 not in bitmap of probed irqs 0
sio4: port may not be enabled
cardbus1: <simple comms, UART> at device 0.1 (no driver attached)

Huh? All PCMCIA cards share the same IRQ and to works OK for the
Ethernet, but not the serial interface. It behaved just fine in the
past.

Due to the LONG time since I last ran it (possibly not sine last
September), it will likely take me a while to track down just when it
broke, so I'm hoping that someone has an idea that could save me some
time.

I don't recall seeing this reported, although there are reports of some
problems with sio devices that might be related.
-- 
R. Kevin Oberman, Network Engineer
Energy Sciences Network (ESnet)
Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab)
E-mail: oberman_at_es.net			Phone: +1 510 486-8634
Received on Wed Mar 24 2004 - 12:42:41 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:48 UTC