Hi Peter, code compiled with no problems but didn't work. I tried a few things and even tried a fresh new installation of -current with a couple of different results but there seems to be a problem with the driver. The behavior of the driver was very similar with -stable as well as with -current. -stable) when compiled in the kernel, kernel crashed on boot. when compiled as a module I got the following error: # kldload digi_Xem # kldload digi digi0 mem 0xe1800000-0xe1bfffff irq 10 at device 11.0 on pci0 . ( and about 5-10 seconds later on ) ... digi0: Cannot init without BIOS Seems that it can not load the BIOS into the card. -current) (5.2.1) had the same problem. Kernel crashed while booting with a very similar error with -stable but came up with a debug prompt. How can I help debug this one? Can anyone please advise? Thank you, Lefteris TsintjelisReceived on Wed May 19 2004 - 05:38:11 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:37:54 UTC