> a lot of people seem to have problems with if_sk. A lot of people consider it simply broken on some boards. > > Let's see if we can find out what problems happen for which people. - watchdog timeouts > - rx/tx "hangs" > - ... It would be great to be able to get my board working with the sk driver. The board is a SysKonnect SK-9844 v1 board (2 x fibre ports). The SysKonnect YK driver works fine under 5.2, but as I need to run a 5.3-RC version I can't use the board until they release a 5.3 version of the driver. The SK driver in FreeBSD always reports "skc0: no PHY found!". Boot info with this patch loaded is as follows: 5.3-BETA6 skc0: <SysKonnect Gigabit Ethernet (V1.0)> port 0xb800-0xb8ff mem 0xf55fc000-0xf55fffff irq 24 at device 2.0 on pci2 skc0: SysKonnect SK-NET Gigabit Ethernet Adapter SK-9844 SX dual link skc0: PN: SK-9844 skc0: EC: Rev. 1.2 skc0: MN: SysKonnect skc0: SN: ZSD12L29A84C8 sk0: <XaQti Corp. XMAC II> on skc0 sk0: Ethernet address: 00:00:5a:9a:84:c8 skc0: no PHY found! device_attach: sk0 attach returned 6 sk1: <XaQti Corp. XMAC II> on skc0 sk1: Ethernet address: 00:00:5a:9a:84:c9 skc1: no PHY found! device_attach: sk1 attach returned 6 Regards, MattReceived on Mon Nov 01 2004 - 22:03:52 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:20 UTC