In message: <08d601c4a954$242380b0$f700000a_at_ape> "Markie" <mark.cullen_at_dsl.pipex.com> writes: : I installed via a 5.3-BETA5 CD and I was able to switch network cards, a : D-Link DWL-G650 and an Intel... can't remember, fxp0 driver; both are : cardbus cards anyway. Now I have updated to 6.0-CURRENT (a few days ago) I : have noticed I can no longer take the card out. If I do, the system appears : appears to hang while running X. : : I just now tried from the console and it's actually a panic. : : : Fatal trap 12: page fault while in kernel mode : cpuid = 0; apic id =00 : fault virtual address 0x3c : fault code = supervisor read, page not present : instruction pointer = 0x8:0xc056a2ce : stack pointer = 0x10:0xc7c86b90 : frame pointer = 0x10:0xc7c86bac : code segment = base 0x0, limit 0xfffff, type 0x1b : = DPL 0, pres 1, def32 1, gran 1 : processor eflags = interrupt enabled, resume, IOPL = 0 : current process = 40 (cbb0) : trap number = 12 : panic: page fault : cpuid = 0 : Uptime: 3m53s : : : You'll probably have to excuse the formatting as that was hand typed. : Curiously, it doesn't come up with the press any key to reboot or anything : and just seems to be stuck there. I don't think that's normal? Perhaps I : should send this to the current list too... : : Any advice? Add DDB into the kernel and give me a traceback. It works for me with the three or four cards I've tried. WarnerReceived on Wed Oct 06 2004 - 01:28:58 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:15 UTC