Re: device pcm

On Sep 05, Marc Fonvieille wrote:
> On Sun, Sep 05, 2004 at 03:05:32PM -0400, Mathew Kanner wrote:
> > 
> > 	Could you add that the easiest way to configure you sound in 5.X+
> > is to:
> > 
> > tube# kldload snd_driver
> > tube# cat /dev/sndstat 
> > FreeBSD Audio Driver (newpcm)
> > Installed devices:
> > pcm0: <CMedia CMI8738> at io 0xb800 irq 11 kld snd_cmi (1p/1r/0v channels duplex default)
> > pcm1: <Creative EMU10K1> at io 0xb400 irq 5 kld snd_emu10k1 (4p/2r/0v channels duplex)
> > 
> > 	for each kld snd_foo
> > 		echo snd_foo_load="YES" >> /boot/loader.conf
> > 
> > 	This method works because snd_driver is just dummy module that
> > loads all[1] the sound modules. (Oops, just noticed I missed uaudio).
> > 	Also, KLDs are the preferred method for sound usage and that ISA
> > cards likely won't need a hint (PNP).
> > 
> > 	--Mat
> > [1]  It only loads the sounds modules that it knew about at compile
> > time.  Some sound modules are provided "third party" such as in the
> > ports, such modules will be missed by this method and will have to be
> > specifically loaded.
> > 
> >
> 
> You did not read the link :(

	Ok, other than you already have a section on PNP what did I
miss?  
	--Mat
-- 
	(on the United States) Living next to you is in some ways
	like sleeping with an elephant. No matter how friendly and
	eventempered the beast, one is affected by every twitch and
	grunt.
			- Pierre Elliott Trudeau