Uro Gruber wrote: > Hello Søren, > > If I understand correctly, I don't have to worry about. My transfer will be > ok then. I just have to wait for a new version to show correct interface in > dmesg. Exactly, I'll look into using the compat mode of the ich6 until I can get my hands on HW and do real AHCI support for it... -Søren > > regards > > Sunday, September 19, 2004, 11:04:51 PM, you wrote: > > SS> Uro Gruber wrote: > >>>Hello! >>> >>>I've notice that freebsd from beta4 does not recognize my sata 150 drive >>>anymore. With beta3 it works now with beta4 or beta5 there's only udma33. >>> >>>I have ICH6 chipset, is there anything I can do. here is my dmesg output > > > SS> The ICH6 is not supported yet (ENOHW), so it will show up as a generic > SS> ATA controller. However since all SATA controllers (at least until we > SS> get SATA-II) always run the interface at 150MB/s thats what you will get > SS> no matter what the probe says (unless you use old PATA disks with > PATA->>SATA converter dongles). > > > > > . >Received on Mon Sep 20 2004 - 03:54:39 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:12 UTC