On Mon, Sep 20, 2004 at 11:10:22AM -0400, Sven Willenberger wrote: +> FreeBSD-5.3-Beta4 +> I created a striped volume, newfs and mounted it fine and added the +> entry in /etc/fstab. (created using the label so as to write the +> metadata to disk and with a name of "thevolume") +> +> I added geom_stripe_load="YES" in /boot/loader.conf +> +> On bootup at the fsck stage, I get the message "could not stat /dev/ +> stripe/thevolume. From single user, geom stripe load will load the +> device and start the stripe at which point all is fine again. My +> question is, is there another flag I need to set to have this startup at +> boot time? If you used 'gstripe label' command to create this stripe it should show up automatically on boot. I wonder if there is no some other problem here, as there was simlar report for gmirror. Could you add: kern.geom.stripe.debug=1 line to your /boot/loader.conf, reboot and send dmesg from after boot? -- Pawel Jakub Dawidek http://www.FreeBSD.org pjd_at_FreeBSD.org http://garage.freebsd.pl FreeBSD committer Am I Evil? Yes, I Am!
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:12 UTC