Re: pri-slave not detected/cable error [Was: Re: HEADSUP: ATAmkIII has been committed]

From: Emanuel Strobl <emanuel.strobl_at_gmx.net>
Date: Sun, 3 Apr 2005 01:03:47 +0200
Am Sonntag, 3. April 2005 00:16 schrieb Søren Schmidt:
> Emanuel Strobl wrote:
> > Am Mittwoch, 30. März 2005 14:07 schrieb Søren Schmidt:
> >>As pr subject make world is needed to get things in sync again.
> >>
> >>Let me know is there are problems / success stories..
> >
> > Hi Søren,
> >
> > -current doesn't detect my primary slave drive while RELENG_5 had no
> > problem. When I connect the slave drive to the secondary port everything
> > is fine. Also, if the slave drive is connected, ata reports that there's
> > no 80pin cable, which is wrong.
>
> Hmm, and you are sure the cable is the right way around ?
>
> Anyhow the output from a verbose boot would be most helpfull, just mail
> it directly to me, thanks!

Just for the archives, Søren was served directly:
http://www.schmalzbauer.de/statics/silberbuechse/verbose_msg_pri-slave.txt
http://www.schmalzbauer.de/statics/silberbuechse/verbose_msg_sec-master.txt

The first is the errornous...

-Harry

Received on Sat Apr 02 2005 - 21:03:49 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:31 UTC