Missing a step in new(er) Remote gdb/kdb setup?

From: Lonnie VanZandt <lonnie.vanzandt_at_ngc.com>
Date: Thu, 4 Aug 2005 09:35:34 -0600
Marcel Moolenaar - or anyone who has properly setup the new remote
gdb/kdb,

       You are, I believe, the programmer for the revised remote kernel debug
interface in FreeBSD 5.4. If so, perhaps you could advise me on why I might
be receiving a "Ignoring packet error, continuing..." at startup from a 
command like:

       kgdb -r /dev/cuaa0 /tmp/kernel.debug

I have verified that I have 9600 8N1 connectivity between the host and
the target and have observed the opening handshake of the remote gdb
protocol being sent from the host. I know the cable and the sios are ok 
because I verified that a getty login over the link worked find.

I have worked with remote kernel debugging on other systems and even on 
FreeBSD in the 5.2.1 release prior to the gdb -k to kgdb switchover. So, I 
think I'm doing the right steps but perhaps something else has changed?

I do have my sio flags set to 0x80 on the target and the target has option
KDB, DDB, and GDB in it. The target drops into the kernel debugger on a 
Ctrl-Alt-Esc and steps into the gdb backend with ">gdb", ">s" commands.

Is there a serial port baud rate setting I need to revise? Also, I properly 
turned off the getty in /etc/ttys on the target for the sio used as the 
debugger console.

Also, how do I get rid of the libthread_db.so undefined symbol reference to
ps_pglobal_lookup?

Both host and target are 5.4 although the host is a 5.2.1 updated to 5.4RC3 
updated to 5.4 RELEASE configuration...

Lonnie VanZandt
Received on Thu Aug 04 2005 - 13:39:34 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:40 UTC