Re: ATI on FreeBSD! FireGL Linux Driver Port

Sounds good!

Also, make sure to add a couple of xorg.conf lines in regards to this as 
explained in the README.

By default, it will try to involve Xv with its GL bits and fail, therefore not 
exposing proper Xv acceleration. (xvinfo will report no available adapters)

By adding the following two lines, the correct "GL-less" accelerated behavior 
will be restored: (These go in the "Device" section)

        Option "VideoOverlay"   "on"
        Option "OpenGLOverlay"  "off"

On Tuesday 27 December 2005 08:33, Joshua Tinnin wrote:
> On Tue 27 Dec 05 00:22, Eric Anholt <eta_at_lclark.edu> wrote:
> > On Tue, 2005-12-27 at 00:10 -0700, Joshua Tinnin wrote:
> > > On Mon 26 Dec 05 22:30, Chris Gilbert <Chris_at_lainos.org> wrote:
> > > > Sure!
> > > >
> > > > Below is a support list based on what ATI reports the driver
> > > > supports.
> > > >
> > > > Everything here should work as advertised, but to be sure, if you
> > > > have success with a particular card then let me know and I'll
> > > > mark the support as confirmed.
> > > >
> > > > It supports: (Put into a sane order, as opposed to what is on the
> > > > ATI site)
> > >
> > > <snip>
> > >
> > > > Radeon® 9600 series
> > >
> > > I have an ATI Radeon 9600XT, and I'm proud to report it's been
> > > working for the last hour with no problems. I can live without the
> > > 3D acceleration in FreeBSD, but 2D acceleration helps
> > > significantly. Finally using my card's memory instead of the
> > > system's.
> >
> > Hmm.  X.Org should be supporting the same 2d acceleration for 9600s
> > as fglrx.  Was that not the case?
>
> Well, rather, it seems to be working much better now. The radeon X.Org
> driver never did seem to do 2D accel very well, at least in my
> experience, though the logs tell me it was working. It seems like it's
> actually working now, though I guess what I said previously wasn't
> precise.
>
> - jt
> _______________________________________________
> freebsd-current_at_freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"