Re: mlx(4) fully and ep(4) partially broken on 6.0

In message: <20050731011147.2c00c819.lehmann_at_ans-netz.de>
            Oliver Lehmann <lehmann_at_ans-netz.de> writes:
: M. Warner Losh wrote:
: 
: > In message: <20050731003652.12223405.lehmann_at_ans-netz.de>
: >             Oliver Lehmann <lehmann_at_ans-netz.de> writes:
: > : same as ep0 wants to run with:
: > : 
: > : ep0: <3Com 3C509-Combo Etherlink III> at port 0x300-0x30f irq 9 on isa0
: > : ep0: No irq?!
: > : panic: resource_list_release: resource entry is not busy
: > : Uptime: 1s
: > 
: > Bummer.  Any chance you can get a traceback?
: 
: Disks are not initialized when the pannic occures...
: Any info I could provide you from within the kdb? A ,,where'' output? Is
: kdb useable from serial console so far?

enable ddb, and use 'trace'.  However, I think I understand where it
is happening.

: > : As you can see, it looks like the card is not configured as PnP (because
: > : that would add "(PnP)" to the description).
: > : 
: > : On my router, fxp3 has irq 9 - Maybe it is irq sharing related? But I
: > : wonder why it works with 5.4 without problems...
: > 
: > You can't share IRQs with ISA bus.  You'll need to find out what
: > changed that causes fxp3 to use irq 9 now.  Maybe it is APIC related?
: 
: As I can see in an old 5.4 dmesg ep0 was the only card with irq9, fxp3
: had 11 on 5.4.

OK.  Sounds like either an unknown changes in the BIOS configuration
(unlikely) or a subtle change in how we route interrupts that the BIOS
doesn't.

Warner