Pascal Hofstee wrote on Sat, Sep 03, 2005 at 06:11:57PM -0700: > On Sat, 2005-09-03 at 21:02 -0400, Martin Cracauer wrote: > > I just turned ACPI off in loader.conf. > > > > Unfortunately it turns out that 7-current on my dual Opteron (Armima > > HDAMB) panics in ata probe when ACPI is off (bug report to follow). > > > > That means I cannot even get into single user mode. I need to load > > ACPI from the loader prompt before booting the kernel. > > > > I tried "load acpi" which does not report an error, but neither a > > loaded module. Booting the kernel afterwards leads to the same panic. > > > > Next I tried to unload the kernel first, but a "load acpi" just loads > > the kernel module, not the acpi module. I assume this is due to me > > having it turned off in loader.conf. > > > > What is the right procedure to do this? Can I tell the bootloader to > > ignore loader.conf? > > Have you tried setting hint.acpi.0.disabled=0 at the boot loader > prompt ? I assume you mean `set hint.acpi.0.disabled=0`. Yes, I tried, and `show` shows it to be zero. It doesn't work either. Setting this, unloading everything and then loading acpi shows the same behavior as before. `load acpi` loads the kernel, no acpi, and a subsequent boot panics. Martin -- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%% Martin Cracauer <cracauer_at_cons.org> http://www.cons.org/cracauer/ FreeBSD - where you want to go, today. http://www.freebsd.org/Received on Sat Sep 03 2005 - 23:40:42 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:42 UTC