Re: Default route doesn't change to wireless device (ath0)

From: John-Mark Gurney <gurney_j_at_resnet.uoregon.edu> Date: Thu, 8 Sep 2005 08:09:53 -0700 · This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:43 UTC

Warner Losh wrote this message on Thu, Sep 08, 2005 at 01:11 -0600:
> In message: <20050907211811.GA19570_at_odin.ac.hmc.edu>
>             Brooks Davis <brooks_at_one-eyed-alien.net> writes:
> : Hmm, upon further testing, I think there may be a problem with the
> : fxp(4) driver.
> 
> You mean like the driver never asynchronously querries the miibus to
> find out what the state of the link is when it isn't in the UP state?

Of the fact that it doesn't reset the phy when you hard code the
speed/duplex setting?  (I have a patch for this.)

This means if you have a switch set for auto, and you then hard set it
for 100mb/full, it will work (since the phy never got reset) at
autoselected speed of 100mb/full until the cable gets pulled, or the
switch reboots, at which time the switch will renegotiate to 100mb/half,
and you're still at 100mb/full...

-- 
  John-Mark Gurney				Voice: +1 415 225 5579

     "All that I will do, has been done, All that I have, has not."