Re: if_re does not work

Hi John,

In Message-ID: <200607111011.52520.jhb_at_freebsd.org>
John Baldwin <jhb_at_freebsd.org> wrote :

> On Tuesday 11 July 2006 01:30, Bill Paul wrote:
> > > Hi all,
> > > 
> > > I have two CardBus card with RealTek 8169SB as follows:
> > > 
> > > NETGEAR GA511
> > > Buffalo LPC-CB-CLGT
> > > 
> > > But they act up from revision 1.68 of if_re.c.
> > 
> > This has nothing to do with the re(4) driver. The problem is that
> > the cardbus code is not allocating an interrupt resource for the device:
> > 
> > > It is a log of NETGEAR GA511 inserting to ThinkPad X40.
> > 
> > It sure is.
> >  
> > > Jul 10 22:54:33 x40 kernel: re0: <RealTek 8169SB/8110SB Single-chip 
> Gigabit Ethernet> port 0x3000-0x30ff mem 0xd0211000-0xd02111ff at device 0.0 
> on cardbus0
> > 
> > Note that there is no 'irq' mentioned anywhere in this line, which is why
> > you get this error:
> > 
> > > Jul 10 22:54:33 x40 kernel: re0: couldn't set up irq
> > 
> > If you really think this is related to the driver, prove it: back out
> > the changes (while keeping the rest of your kernel the same) and see if
> > it works again. I don't think it will.
> 
> In theory the bus_alloc_resource(.., SYS_RES_IRQ, ...) should route an 
> interrupt for the re0 device but it won't show up in the probe line in that 
> case since the probe line is printed before re_attach() is called.  In fact,
> in the failing case, it wasn't bus_alloc_resource() that failed, but
> bus_setup_intr().  This is most likely not an re0 issue however.
> 
> goto-san, can you add printf's to i386/i386/intr_machdep.c:intr_add_handler()
> and kern/kern_intr.c:intr_event_add_handler() to see which of the EINVAL
> cases is being triggered?

I added printf() to 2 functions (one in intr_add_handler() and two
in intr_event_add_handler()) and re-build my kernel and reboot my
ThinkPad X40. But I could not get any printf's messages.

And I have a question. Why INTR_FAST was added in re_attach()?
When I deleted it and re-build if_re modules, my card was attached.
But I got another error messages and panic if interface is up.
(mutex re0 not owned at...)

Goto.


-=-=-=-
// Yoshikazu GOTO
// E-mail: goto_at_snowy.to
-=-=-=-
\e