I'm trying to get FreeBSD installed on one of my systems and I'm getting the error stated below. I did have FreeBSD 6-STABLE installed a few months ago on this very system. The only change is that FreeBSD is now installed on the second harddrive instead of the first. This is using the -CURRENT snapshot for this month. The install goes just fine. I also get a very similar error when I install 6.1 too. This seems to be the same problem as: http://unix.derkeiler.com/Mailing-Lists/FreeBSD/stable/2006-03/msg00539.html But I don't have a built-in compact flash reader attached via. ATA. Full verbose boot+backtrace: http://am-productions.biz/docs/boot-panic-script.txt.gz rr232x: no controller detected. ata0-slave: pio=PIO4 wdma=WDMA2 udma=UDMA100 cable=80 wire ata0-master: pio=PIO4 wdma=WDMA2 udma=UDMA66 cable=80 wire ad0: setting PIO4 on nForce2 Pro chip ad0: setting UDMA66 on nForce2 Pro chip ad0: 17206MB <IBM DJNA-371800 J78OA30K> at ata0-master UDMA66 Fatal trap 18: integer divide fault while in kernel mode cpuid = 0; apic id = 00 instruction pointer = 0x20:0xc089b49f stack pointer = 0x28:0xc0c20b64 frame pointer = 0x28:0xc0c20bec code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 0 (swapper) [thread pid 0 tid 0 ] Stopped at __qdivrem+0x3b: divl %ecx,%eax db> bt Tracing pid 0 tid 0 td 0xc0a02fb8 __qdivrem(219b700,0,0,0,0) at __qdivrem+0x3b __udivdi3(219b700,0,0,0) at __udivdi3+0x16 ad_describe(c26e8580,c26e8580,c262c280,c265e400,c25ec200) at ad_describe+0x1b3 ad_attach(c26e8580) at ad_attach+0x1e7 device_attach(c26e8580,c0957850,c26e8580,c265e000,c265e400) at device_attach+0x58 device_probe_and_attach(c26e8580) at device_probe_and_attach+0xe0 bus_generic_attach(c25d2a80,c25d2a80,1,0,c26e8580) at bus_generic_attach+0x16 ata_identify(c25d2a80) at ata_identify+0x1c8 ata_boot_attach(0) at ata_boot_attach+0x3e run_interrupt_driven_config_hooks(0,c1ec00,c1e000,0,c0450af5) at run_interrupt_driven_config_hooks+0x18 mi_startup() at mi_startup+0x96 begin() at begin+0x2c db> ps -- Anish Mistry
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:38:57 UTC