On Fri, Jun 08, 2007 at 06:18:04PM +0000, Poul-Henning Kamp wrote: > > I have the exact same behaviour with if_re in my "zepto 6615WD" > laptop. > > Dmesg: > re0: <RealTek 8168/8111B PCIe Gigabit Ethernet> port 0x3000-0x30ff mem 0xcc000000-0xcc000fff irq 16 at device 0.0 on pci2 > miibus0: <MII bus> on re0 > rgephy0: <RTL8169S/8110S media interface> PHY 1 on miibus0 > rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto > re0: Ethernet address: 00:a0:d1:c1:f9:ad > re0: [FILTER] > Would you let me know model/revision of the PHY? I guess it uses newer transceiver, RTL8211B(L), from RealTek. > Poul-Henning > > In message <20070608175338.B701745042_at_ptavv.es.net>, "Kevin Oberman" writes: > >--==_Exmh_1181325218_81135P > > > >Yesterday I updated my laptop for the first time since May 10. The > > > >The bge device does not auto-negotiate. > > > >After booting to single-user, but device looks fine > >media: Ethernet autoselect (100baseTX <full-duplex>) > >status: active > > > >As soon as I do 'ifconfig bge0 up', the link goes down and I see: > >media: Ethernet autoselect (none) > >status: no carrier > > > >If I manually set the media to 100baseTX, it comes up. If I set it back > >to autoselect, it again reports "media: Ethernet autoselect (none)" and > >"Status: no carrier". > > -- > Poul-Henning Kamp | UNIX since Zilog Zeus 3.20 > phk_at_FreeBSD.ORG | TCP/IP since RFC 956 > FreeBSD committer | BSD since 4.3-tahoe > Never attribute to malice what can adequately be explained by incompetence. > _______________________________________________ > freebsd-current_at_freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-current > To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org" -- Regards, Pyun YongHyeonReceived on Sat Jun 09 2007 - 00:18:36 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:12 UTC