Re: Disappearing userland output with -current

From: Hidetoshi Shimokawa <simokawa_at_FreeBSD.ORG>
Date: Thu, 14 Jun 2007 22:20:03 +0900
Could you show me the output of  conscontrol(8)?

On 6/14/07, Gary Jennejohn <garyj_at_jennejohn.org> wrote:
> I'm observing a strange problem with a -current i386 box (with SMP)
> built on Wed Jun 13 20:34:11 CEST 2007 after a cvsup and haven't seen
> anyone else reporting it.
>
> The problem occurs whenever the output from the boot phase is garbled,
> almost always because this output:
>         SMP: AP CPU #1 Launched!
> messes up this output (or similar):
>         cd0: cd present [2222160 x 2048 byte records]
>
> The symptom is that _all_ userland output disappears, which makes it
> rather difficult to do anything. I'm forced to reboot the box until
> the boot output isn't trashed.
>
> If I break into ddb then all the output becomes visible, but leaving
> ddb then results in no userland output appearing again.
>
> I noticed this problem for the very first time after gcc42 was imported.
> In all the years I've been using FreeBSD (since 1993) I've never seen
> any behavior like this before. This leads me to strongly suspect some
> fallout from gcc42.
>
> Has anyone else seen this?
>
> ---
> Gary Jennejohn / garyjATjennejohnDOTorg gjATfreebsdDOTorg
> garyjATdenxDOTde
> _______________________________________________
> freebsd-current_at_freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org"
>


-- 
/\ Hidetoshi Shimokawa
\/  simokawa_at_FreeBSD.ORG
Received on Thu Jun 14 2007 - 11:20:05 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:12 UTC