Ulf Lilleengen wrote: > I tried the patch, but I end up with the partition table being incorrectly > read (probably) on the drives connected to my TX4 card. Normally, there's > one partition on the drive, but when I apply the patch, the drive provider > (ad6) is all that shows up in /dev. > > When I revert the patch, the partition (ad6s1) shows up in /dev again. > > I applied both the ata-chipset patch and ata-dma patch to a RELENG_7 system. > > You should try the attached "official" patch and let me know if that helps, thanks! -Søren ? promise-fix2 Index: ata-chipset.c =================================================================== RCS file: /home/ncvs/src/sys/dev/ata/ata-chipset.c,v retrieving revision 1.202.2.2 diff -u -r1.202.2.2 ata-chipset.c --- ata-chipset.c 31 Oct 2007 19:59:53 -0000 1.202.2.2 +++ ata-chipset.c 11 Nov 2007 17:08:49 -0000 _at__at_ -142,6 +142,7 _at__at_ static int ata_promise_mio_command(struct ata_request *request); static void ata_promise_mio_reset(device_t dev); static void ata_promise_mio_dmainit(device_t dev); +static void ata_promise_mio_setprd(void *xsc, bus_dma_segment_t *segs, int nsegs, int error); static void ata_promise_mio_setmode(device_t dev, int mode); static void ata_promise_sx4_intr(void *data); static int ata_promise_sx4_command(struct ata_request *request); _at__at_ -792,6 +793,7 _at__at_ prd[i].dbc = htole32((segs[i].ds_len - 1) & ATA_AHCI_PRD_MASK); } } + KASSERT(nsegs <= ATA_DMA_ENTRIES, "too many DMA segment entries\n"); args->nsegs = nsegs; } _at__at_ -2760,6 +2762,8 _at__at_ prd[i].addrhi = htole32((u_int64_t)segs[i].ds_addr >> 32); } prd[i - 1].count |= htole32(ATA_DMA_EOT); + KASSERT(nsegs <= ATA_DMA_ENTRIES, "too many DMA segment entries\n"); + args->nsegs = nsegs; } static void _at__at_ -3288,9 +3292,13 _at__at_ /* prime fake interrupt register */ ATA_OUTL(ctlr->r_res2, fake_reg, 0xffffffff); - /* clear SATA status */ + /* clear SATA status and unmask interrupts */ ATA_OUTL(ctlr->r_res2, stat_reg, 0x000000ff); + /* enable "long burst lenght" on gen2 chips */ + if ((ctlr->chip->cfg2 == PRSATA2) || (ctlr->chip->cfg2 == PRCMBO2)) + ATA_OUTL(ctlr->r_res2, 0x44, ATA_INL(ctlr->r_res2, 0x44) | 0x2000); + ctlr->allocate = ata_promise_mio_allocate; ctlr->reset = ata_promise_mio_reset; ctlr->dmainit = ata_promise_mio_dmainit; _at__at_ -3778,8 +3786,42 _at__at_ static void ata_promise_mio_dmainit(device_t dev) { + struct ata_channel *ch = device_get_softc(dev); + /* note start and stop are not used here */ ata_dmainit(dev); + if (ch->dma) + ch->dma->setprd = ata_promise_mio_setprd; +} + + +#define MAXLASTSGSIZE (32 * sizeof(u_int32_t)) +static void +ata_promise_mio_setprd(void *xsc, bus_dma_segment_t *segs, int nsegs, int error) +{ + struct ata_dmasetprd_args *args = xsc; + struct ata_dma_prdentry *prd = args->dmatab; + int i; + + if ((args->error = error)) + return; + + for (i = 0; i < nsegs; i++) { + prd[i].addr = htole32(segs[i].ds_addr); + prd[i].count = htole32(segs[i].ds_len); + } + if (segs[i - 1].ds_len > MAXLASTSGSIZE) { + //printf("split last SG element of %u\n", segs[i - 1].ds_len); + prd[i - 1].count = htole32(segs[i - 1].ds_len - MAXLASTSGSIZE); + prd[i].count = htole32(MAXLASTSGSIZE); + prd[i].addr = htole32(segs[i - 1].ds_addr + + (segs[i - 1].ds_len - MAXLASTSGSIZE)); + nsegs++; + i++; + } + prd[i - 1].count |= htole32(ATA_DMA_EOT); + KASSERT(nsegs <= ATA_DMA_ENTRIES, "too many DMA segment entries\n"); + args->nsegs = nsegs; } static void _at__at_ -4849,6 +4891,8 _at__at_ prd[i].count = htole32(segs[i].ds_len); } prd[i - 1].control = htole32(ATA_DMA_EOT); + KASSERT(nsegs <= ATA_DMA_ENTRIES, "too many DMA segment entries\n"); + args->nsegs = nsegs; } static void Index: ata-dma.c =================================================================== RCS file: /home/ncvs/src/sys/dev/ata/ata-dma.c,v retrieving revision 1.147 diff -u -r1.147 ata-dma.c --- ata-dma.c 8 Apr 2007 21:53:52 -0000 1.147 +++ ata-dma.c 11 Nov 2007 17:08:49 -0000 _at__at_ -213,6 +213,7 _at__at_ prd[i].count = htole32(segs[i].ds_len); } prd[i - 1].count |= htole32(ATA_DMA_EOT); + KASSERT(nsegs <= ATA_DMA_ENTRIES, "too many DMA segment entries\n"); args->nsegs = nsegs; } _______________________________________________ freebsd-hackers_at_freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-hackers To unsubscribe, send any mail to "freebsd-hackers-unsubscribe_at_freebsd.org"Received on Fri Nov 16 2007 - 14:46:36 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:22 UTC