Ian FREISLICH wrote: > I have two systems that I think are HT1000/HT2100 based. They > booted and installed 7-BETA1.5 (amd64) and happily build RELENG7 > about 3 weeks ago. They don't have any PCI/PCI-X slots. PCI-E > works fine. I used the onboard ATA DVD-ROM drive to install and > the drive still works: > > ATA channel 0: > Master: acd0 <HL-DT-STCD-RW/DVD-ROM GCC-T10N/A102> ATA/ATAPI revision 5 > Slave: no device present > ATA channel 1: > Master: no device present > Slave: no device present > ATA channel 2: > Master: no device present > Slave: no device present > ATA channel 3: > Master: no device present > Slave: no device present > > Disks are connected to a PCI-E LSI Megaraid so I can't verify the > onboard SATA. pciconf -lv later. > > The only other quirk is the one set of USB ports on the front panel > work if I have a keyboard plugged in at boot time, but stops working > if I unplug the keyboard and plug it back in again. The front panel > monitor connection also doesn't work after a headless boot. Anly > the rear monitor and USB ports work properly after a boot. My motherboard is PCI-X rather than PCI Express, though... It could be real handy if you could verify that there's no problem with your onboard SATA in standard SATA (non-legacy) mode, if that box happens to be near you :) You must be careful, though, any disk with existing data on it that you plug into the onboard SATA controller has a chance of being horribly corrupted just by booting from it, assuming you run into the same problems as us. I am having the nasty data corruption problems using the onboard SATA controller as well as an 8-port Marvell SATA controller plugged into the motherboard's PCI-X slot. I've had no problems with the dvd-rom drive that's plugged into the onboard PATA controller. I do not have any problem with a PCI SiI3114 SATA controller plugged into one of the 32-bit PCI slots. If it helps anybody, I'll stick my pciconf -lv at the end of my post, too... -- TerraNovaNet Internet Services - Key Largo, FL Voice: (305)453-4011 x101 Fax: (305)451-5991 http://www.terranova.net/ ---------------------------------------------- Life's not fair, but the root password helps. pcib1_at_pci0:0:1:0: class=0x060400 card=0x00000000 chip=0x00361166 rev=0x00 hdr=0x01 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'HT1000 PCI/PCI-X bridge' class = bridge subclass = PCI-PCI hostb0_at_pci0:0:2:0: class=0x060000 card=0x02011166 chip=0x02051166 rev=0x00 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'HT1000 Legacy South Bridge' class = bridge subclass = HOST-PCI atapci1_at_pci0:0:2:1: class=0x01018a card=0x02141166 chip=0x02141166 rev=0x00 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'HT1000 Legacy IDE controller' class = mass storage subclass = ATA isab0_at_pci0:0:2:2: class=0x060100 card=0x02301166 chip=0x02341166 rev=0x00 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'HT1000 LPC Bridge' class = bridge subclass = PCI-ISA none0_at_pci0:0:3:0: class=0x0c0310 card=0x02231166 chip=0x02231166 rev=0x01 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = '0x0223 USB controller' class = serial bus subclass = USB none1_at_pci0:0:3:1: class=0x0c0310 card=0x02231166 chip=0x02231166 rev=0x01 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = '0x0223 USB controller' class = serial bus subclass = USB none2_at_pci0:0:3:2: class=0x0c0320 card=0x02231166 chip=0x02231166 rev=0x01 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = '0x0223 USB controller' class = serial bus subclass = USB em0_at_pci0:0:4:0: class=0x020000 card=0x387010f1 chip=0x10768086 rev=0x05 hdr=0x00 vendor = 'Intel Corporation' device = '82541EI Gigabit Ethernet Controller' class = network subclass = ethernet em1_at_pci0:0:5:0: class=0x020000 card=0x387010f1 chip=0x10768086 rev=0x05 hdr=0x00 vendor = 'Intel Corporation' device = '82541EI Gigabit Ethernet Controller' class = network subclass = ethernet vgapci0_at_pci0:0:6:0: class=0x030000 card=0x002018ca chip=0x002018ca rev=0x00 hdr=0x00 vendor = 'XGI Technology Inc' class = display subclass = VGA atapci2_at_pci0:0:7:0: class=0x010400 card=0x61141095 chip=0x31141095 rev=0x02 hdr=0x00 vendor = 'Silicon Image Inc (Was: CMD Technology Inc)' device = 'Sil 3114 SATALink/SATARaid Controller' class = mass storage subclass = RAID hostb1_at_pci0:0:24:0: class=0x060000 card=0x00000000 chip=0x11001022 rev=0x00 hdr=0x00 vendor = 'Advanced Micro Devices (AMD)' device = '(K8) Athlon 64/Opteron HyperTransport Technology Configuration' class = bridge subclass = HOST-PCI hostb2_at_pci0:0:24:1: class=0x060000 card=0x00000000 chip=0x11011022 rev=0x00 hdr=0x00 vendor = 'Advanced Micro Devices (AMD)' device = '(K8) Athlon 64/Opteron Address Map' class = bridge subclass = HOST-PCI hostb3_at_pci0:0:24:2: class=0x060000 card=0x00000000 chip=0x11021022 rev=0x00 hdr=0x00 vendor = 'Advanced Micro Devices (AMD)' device = '(K8) Athlon 64/Opteron DRAM Controller' class = bridge subclass = HOST-PCI hostb4_at_pci0:0:24:3: class=0x060000 card=0x00000000 chip=0x11031022 rev=0x00 hdr=0x00 vendor = 'Advanced Micro Devices (AMD)' device = '(K8) Athlon 64/Opteron Miscellaneous Control' class = bridge subclass = HOST-PCI pcib2_at_pci0:1:13:0: class=0x060400 card=0x4f00d7f7 chip=0x01041166 rev=0xc0 hdr=0x01 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'HT1000 PCI/PCI-X bridge' class = bridge subclass = PCI-PCI atapci0_at_pci0:1:14:0: class=0x010405 card=0x024a1166 chip=0x024a1166 rev=0x00 hdr=0x00 vendor = 'ServerWorks (Was: Reliance Computer Corp)' device = 'BCM5785 (HT1000) SATA Native SATA Mode' class = mass storage subclass = RAIDReceived on Wed Nov 21 2007 - 15:07:15 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:22 UTC