Re: vge(4) driver not working at 1G speeds

From: Pyun YongHyeon <pyunyh_at_gmail.com> Date: Wed, 2 Apr 2008 17:16:43 +0900 · This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:29 UTC

On Wed, Apr 02, 2008 at 08:29:27AM +0100, Stuart Fraser wrote:
 > Hi,
 > Here is the dmesg section, it appears to be using UKPHY so as you say if the
 > older chips used a different physical layer perhaps we have a problem in
 > there.
 > 
 > -- dmesg --
 > pci3: <ACPI PCI bus> on pcib3
 > vge0: <VIA Networking Gigabit Ethernet> port 0xe800-0xe8ff mem
 > 0xfeaffc00-0xfeaffcff irq 28 at device 0.0 on pci3
 > miibus0: <MII bus> on vge0
 > ukphy0: <Generic IEEE 802.3u media interface> PHY 22 on miibus0

This is the reason why I requested verbosed boot messages.
ukphy(4) prints OUI/model number of the PHY in verbosed boot mode.
Would you show me that information?

 > ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
 > 1000baseT-FDX, auto
 > vge0: using obsoleted if_watchdog interface
 > vge0: Ethernet address: 00:40:63:f3:7e:28
 > vge0: [ITHREAD]
 > 

-- 
Regards,
Pyun YongHyeon