Re: vge(4) driver not working at 1G speeds

From: Pyun YongHyeon <pyunyh_at_gmail.com>
Date: Wed, 2 Apr 2008 17:52:07 +0900
On Wed, Apr 02, 2008 at 09:30:40AM +0100, Stuart Fraser wrote:
 > Oops, no coffee yet, here you go.
 > 
 > pcib3: slot 0 INTA hardwired to IRQ 28
 > vge0: <VIA Networking Gigabit Ethernet> port 0xe800-0xe8ff mem
 > 0xfeaffc00-0xfeaffcff irq 28 at device 0.0 on pci3
 > vge0: Reserved 0x100 bytes for rid 0x14 type 3 at 0xfeaffc00
 > miibus0: <MII bus> on vge0
 > ukphy0: <Generic IEEE 802.3u media interface> PHY 22 on miibus0
 > ukphy0: OUI 0x0090c3, model 0x0019, rev. 0
 > ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
 > 1000baseT-FDX, auto
 > vge0: using obsoleted if_watchdog interface
 > vge0: bpf attached
 > vge0: Ethernet address: 00:40:63:f3:7e:28
 > ioapic1: routing intpin 4 (PCI IRQ 28) to vector 49
 > vge0: [MPSAFE]
 > vge0: [ITHREAD]
 > 

Thanks a lot! Try attached patch and let me know how it goes.

-- 
Regards,
Pyun YongHyeon
Received on Wed Apr 02 2008 - 06:52:25 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:29 UTC