Here's an example: $ sudo ./st -i /dev/sg2 /dev/sg2 Vendor = SEAGATE Product = ST3146707LC Version = 0004 Serial Number = 3KS2NFJG Copyright = Copyright (c) 2005 Seagate All rights reserved SCSI Firmware = 06070004 Servo RAM Release = 2005CB5A Servo ROM Release = 00000000 Servo RAM Date = CB5A Servo ROM Date = 2005 Blocksize = 512, Highblock = 286749487, Capacity = 143375 MB -this is a Seagate drive -this drive supports DST -short DST time = 120 seconds -long DST time = 2726 seconds -Mode Page Settings [current value (default)]: -WCE bit = 1 (1) -RCD bit = 0 (0) -AWRE bit = 1 (1) -ARRE bit = 1 (1) -DExcpt bit = 0 (0) -Number of cache segments = 32 (32) -PM bit = 0 (0) -DLM bit = 0 (0) -DTOLI bit = 0 (0) -JIT bit 0 = 1 (1) -JIT bit 1 = 1 (1) -JIT bit 2 = 1 (1) -JIT bit 3 = 1 (1) $ sudo ./st -t 10 /dev/sg2 Starting 10 % short DST on drive/dev/sg2 read_capacity (SG_IO) error: Bad address DST test FAILED on drive /dev/sg2 (Sense data = 00/20/00) $ -- Larry Rosenman http://www.lerctr.org/~ler Phone: +1 512-248-2683 E-Mail: ler_at_lerctr.org US Mail: 430 Valona Loop, Round Rock, TX 78681-3893Received on Fri Aug 15 2008 - 14:13:12 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:33 UTC