On Sat, Dec 27, 2008 at 02:34:32PM -0500, Robert Noland wrote: > On Sat, 2008-12-27 at 20:17 +0100, Alexey Shuvaev wrote: > > On Sat, Dec 27, 2008 at 02:01:58PM -0500, Robert Noland wrote: > > > I have a linksys wpc54g v2 card which is a 111 part. The updated port > > > does not autoload the firmware, but if I manually load the firmware, > > > then it attaches. It doesn't quite work though. > > > > > Nice (I mean that it attaches, at least :)! > > Developer suggests loading appropriate firmware first. > > You also need to use specialized acxtool, it is installed by the port. > > See (at the bottom): http://dev.kewl.org/acx100+111/ > > (and man page if_axc(4) too). > > Does this pushes the card to work? > > acxtool does seem to set the ssid and channel, though it still doesn't > seem to associate. Note that I am on -CURRENT. ifconfig continues to > complain that channel is undefined regardless of what it is set to. > > wombat% sudo acxtool acx0 -S "2HIP" -M managed -C 5 > Setting ssid to 2HIP > Setting infrastructure ess/bss capability > Setting channel to 5 > wombat% ifconfig > acx0: flags=8803<UP,BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500 > ether 00:0f:66:c6:d7:f2 > media: IEEE 802.11 Wireless Ethernet autoselect > status: no carrier > ifconfig: unable to get HT configuration information: Invalid argument > ifconfig: unknown/undefined channel number 5 flags 0x0 > ssid 2HIP% > > robert. > And what does 'sudo acxtool acx0' say after you have tried to configure interface with acxtool with parameters? Anyway, seems it does not play good with CURRENT :( Alexey.Received on Sat Dec 27 2008 - 18:44:33 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:39 UTC