Re: ifconfig ath0 list mac - no list

From: Sam Leffler <sam_at_errno.com>
Date: Sat, 02 Feb 2008 21:20:48 -0800
JoaoBR wrote:
> 
> # ifconfig ath0 list mac
> policy: allow
> #
> 
> actually on recent sources this command does not return the mac acl only the 
> state

This lists installed acls.  I don't see you installing any.

> 
> 
> 
> 
> -------------
> 
> next problem that the rate is shown always as 1M, before last buildworld it 
> still was 11M
> 
> # ifconfig ath0 list stat
> ADDR               AID CHAN RATE RSSI IDLE  TXSEQ  RXSEQ CAPS FLAG
> 00:0e:2e:89:23:30    1    1   1M 18.0   15  20496  55152 EPS  A
> 00:0e:2e:86:d4:14    3    1   1M 19.5   15   1016  35552 EPS  A
> 00:06:4f:44:a0:d6    4    1   1M 11.5    0  21467  10624 EPS  A
> 00:08:54:ac:54:3e    5    1   1M 13.5    0    804  59408 EPS  A
> 00:0f:3d:68:1d:31    6    1   1M 14.5    0  10187  12928 EP   A

What rate control algorithm?

> 
> 
> 
> FreeBSD ap-n.matik.com.br 7.0-PRERELEASE FreeBSD 7.0-PRERELEASE #0: Sat Jan 19 
> 21:36:10 BRST 2008     hmm_at_ap-n.matik.com.br:/usr/obj/usr/src/sys/wce7  amd64
> 
> ath0: <Atheros 5212> mem 0xec000000-0xec00ffff irq 16 at device 8.0 on pci0
> ath0: [ITHREAD]
> ath0: using obsoleted if_watchdog interface
> ath0: Ethernet address: 00:02:6f:47:c1:42
> ath0: mac 10.4 phy 6.1 radio 6.3
> 

Please show how your devices is setup.

	Sam
Received on Sun Feb 03 2008 - 04:20:50 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:26 UTC