I have a new Dell Latitude D530 laptop with builtin wireless. During boot up, I see wpi0: <Intel(R) PRO/Wireless 3945ABG> mem 0xfe8ff000-0xfe8fffff irq 17 at device 0.0 on pci12 bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. bus_dmamem_alloc failed to align memory properly. wpi0: Ethernet address: 00:1c:bf:90:ab:44 wpi0: [ITHREAD] wpi0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps wpi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps wpi0: Ethernet address: 00:1c:bf:90:ab:44 wpi0: [ITHREAD] wpi0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps wpi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps wpi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps Upon running ifconfig wpi0 inet 192.168.0.10 ifconfig wpi0 ssid "HomeNetwork" mode 11g channel 11 wepmode on ifconfig wpi0 wepkey 0xsome_valid_key_here deftxkey 1 I see an endless stream of Feb 10 16:43:45 mobile kernel: wpi0: fatal firmware error Feb 10 16:43:45 mobile last message repeated 3 times Feb 10 16:43:46 mobile kernel: wpi0: could not setup MRR for control frames Feb 10 16:43:46 mobile kernel: wpi0: could not setup MRR Feb 10 16:43:46 mobile kernel: wpi0: fatal firmware error Feb 10 16:44:29 mobile last message repeated 90 times Feb 10 16:44:38 mobile last message repeated 44 times Feb 10 16:44:40 mobile shutdown: reboot by root: Feb 10 16:44:40 mobile kernel: wpi0: fatal firmware error Feb 10 16:44:42 mobile last message repeated 15 times Feb 10 16:44:42 mobile syslogd: exiting on signal 15 Is this a known problem? -- SteveReceived on Sun Feb 10 2008 - 23:58:44 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:27 UTC