Hi all I believe I'm having a few problems with using geom to label disks and then use them in zfs. # zpool status rootzfs pool: rootzfs state: ONLINE scrub: none requested config: NAME STATE READ WRITE CKSUM rootzfs ONLINE 0 0 0 mirror ONLINE 0 0 0 label/sysdisk_A ONLINE 0 0 0 label/sysdisk_B ONLINE 0 0 0 errors: No known data errors # glabel status Name Status Components label/bootdisk_A N/A ad0s1a label/swap_A N/A ad0s1b label/sysdisk_A N/A ad0s1d label/bootdisk_B N/A ad2s1a label/swap_B N/A ad2s1b label/sysdisk_B N/A ad2s1d # gmirror status Name Status Components mirror/swap_AB COMPLETE label/swap_A label/swap_B # swapinfo Device 1K-blocks Used Avail Capacity /dev/mirror/swap_AB 4194300 158224 4036076 4% # mount -t ufs /dev/label/bootdisk_A on /bootdirA (ufs, local) /dev/label/bootdisk_B on /bootdirB (ufs, local) As can be seen I have the boot disk set up with separate /boot partitions (independent of each other), mirrored swap and the rest of the root file system in zfs. Currently I am watching the following appearing every second or two in the messages file: kernel: vdev_geom_detach:177[1]: Closing access to label/sysdisk_B. kernel: vdev_geom_detach:177[1]: Closing access to label/sysdisk_A. kernel: vdev_geom_detach:181[1]: Destroyed consumer to label/sysdisk_A. kernel: vdev_geom_detach:177[1]: Closing access to label/sysdisk_B. kernel: vdev_geom_detach:181[1]: Destroyed consumer to label/sysdisk_B. kernel: vdev_geom_open:371[1]: Found provider by name /dev/label/sysdisk_A. kernel: vdev_geom_attach:116[1]: Attaching to label/sysdisk_A. kernel: vdev_geom_attach:157[1]: Created consumer for label/sysdisk_A. kernel: vdev_geom_open:385[1]: ID match for provider /dev/label/sysdisk_A. kernel: vdev_geom_open:371[1]: Found provider by name /dev/label/sysdisk_B. kernel: vdev_geom_attach:116[1]: Attaching to label/sysdisk_B. kernel: vdev_geom_attach:157[1]: Created consumer for label/sysdisk_B. kernel: vdev_geom_open:385[1]: ID match for provider /dev/label/sysdisk_B. much of the time only one disk is "lost" at a time. I also get "kernel: ZFS WARNING: Cannot open ad2 for writting" (also for ad0) upon imports etc. I'm running 7.0-RELEASE-p2 on amd64. I also have another raidz set of 6 disks, but I don't use labels on them and have no messages as a result. Any suggestions if I should be concerned or not. I also have periodic lockups (under load) which I believe are zfs related, but I have only just set up the serial console and I am waiting to get a crash dump. regards DuncanReceived on Sun Jul 06 2008 - 10:00:51 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:32 UTC