Hi. Today I was testing Again the ATH card with the same motherboard but in FreeBSD 7.0. I get exactly the same problem of the irq storm but at least I can use the card after change : sysctl hw.intr_storm_threshold=10000 ( or more) But if you try to do anything with the wireless card the console or ssh or telnet hang up until the transmission is finish, after you finish playing with the wireless card everything is back to normal, so definitely a high storm_threshold is not the solution. I will try the same wireless card in a Acer Laptop with freebsd 7.0 and 8 and I will update the results. We want to use FreeBSD for more than 100 Radios, so this could be a enormous Live-Lab :) Thanks in advance. On 2-Jun-08, at 10:47 PM, Jose Amengual M wrote: > I'm the only one with this problem ? > > Any help ? > > Thanks. > > > On 26-May-08, at 12:43 PM, Jose Amengual M wrote: > >> Hi guys. >> >> I'm working with FreeBSD 8.0 current using tinybsd to make a image >> for my Soekris 4511 box. >> >> The build image is ok and the system boot up perfect, It detect all >> the network cards includin the ath0 that is a 400 mw NMP-8602 PLUS. >> >> In the moment that I do : >> >> ifconfig wlan create wlandev ath0 >> ifconfig wlan up >> >> I'm reciving this : >> >> interrupt storm detected on "irq11:"; throttling interrupt source >> >> and is only when I take up the wlan0 interface, if I don't do >> anything with the ath0 card, the system works perfect. >> >> I search in the net for an info and I found a lot of information >> about how to build FreeBSD in Soekris boxes, kernel conf files, >> etc, but nothing about this caind of problem in version 8.0. >> >> My vmstat -i is : >> >> tinybsd# vmstat -i >> interrupt total rate >> irq0: clk 170695 490 >> irq4: sio0 1993 5 >> irq8: rtc 43697 125 >> irq9: sis1 392 1 >> irq11: ath0 32626 93 >> irq14: ata0 16261 46 >> Total 265664 763 >> >> my pciconf -lv is : >> >> tinybsd# pciconf -lv >> hostb0_at_pci0:0:0:0: class=0x060000 card=0x00000000 >> chip=0x30001022 rev=0x00 hdr=0x00 >> class = bridge >> subclass = HOST-PCI >> cbb0_at_pci0:0:9:0: class=0x060700 card=0x00000000 >> chip=0xac50104c rev=0x02 hdr=0x02 >> class = bridge >> subclass = PCI-CardBus >> ath0_at_pci0:0:16:0: class=0x020000 card=0x2062168c >> chip=0x001b168c rev=0x01 hdr=0x00 >> class = network >> subclass = ethernet >> sis0_at_pci0:0:18:0: class=0x020000 card=0x0020100b >> chip=0x0020100b rev=0x00 hdr=0x00 >> class = network >> subclass = ethernet >> sis1_at_pci0:0:19:0: class=0x020000 card=0x0020100b >> chip=0x0020100b rev=0x00 hdr=0x00 >> class = network >> subclass = ethernet >> >> >> My dmesg with ath part : >> >> ath0: <Atheros 5212> mem 0xa0010000-0xa001ffff irq 11 at device >> 16.0 on pci0 >> ath0: [ITHREAD] >> ath0: WARNING: using obsoleted if_watchdog interface >> ath0: mac 10.5 phy 6.1 radio 6.3 >> sis0: <NatSemi DP8381[56] 10/100BaseTX> port 0xe100-0xe1ff mem >> 0xa0020000-0xa0020fff irq 5 at device 18.0 on pci0 >> sis0: Silicon Revision: DP83816A >> >> >> I can send more information if is needed. >> >> I already change the wireless card ( I have for of the same) and >> the matherboard, I upgrade the bios of the Soekris board to 1.38. >> >> Any ideas about the irq storm ? >> >> any special configurations ? >> >> Thanks in advance. >> >> Jose Amengual. >> >> >> _______________________________________________ >> freebsd-current_at_freebsd.org mailing list >> http://lists.freebsd.org/mailman/listinfo/freebsd-current >> To unsubscribe, send any mail to "freebsd-current-unsubscribe_at_freebsd.org >> " >Received on Sat Jun 07 2008 - 04:48:26 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:31 UTC