On 28Jun, 2008, at 12:49 , Garrett Cooper wrote: > On Sat, Jun 28, 2008 at 2:02 AM, Søren Schmidt <sos_at_freebsd.org> > wrote: >> >> Erm, this makes no sense at all. You state you use the "iir" driver >> for the >> card, yet you expect to see the devices under ATA ? Those are two >> very >> different animals, you can't use them together in away way or >> fashion on the >> same drives. >> >> That asks the question: which one is it ? >> >> If you use "iir" I have no idea how/if a rebuild is possible under >> FreeBSD, >> however it could be in the BIOS or with any other OS that supports >> it (here >> the HW should have kept your parity data intact). >> >> If you use ATA you shouldn't have used RAID5 as the docs tell you, >> as there >> will be no parity data to rebuild from no matter what BIOS/OS you >> use -> you >> will get garbage no matter what. > > Uhm... ok, I'll bite. What documentation states how to use RAID's > under FreeBSD properly? The GEOM docs didn't seem to be what I was > looking for back then. Depends on what controller you are using, that is still the question ? -Søren >Received on Sat Jun 28 2008 - 10:29:24 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:32 UTC