Re: problem with Marvell ATA on current

On 24.11.2008 02:44, Xin LI wrote:
> Anton Yuzhaninov wrote:
>> Marvell ATA controller on current (from Nov 20, amd64) don't work under
>> load
>> (e. g. when make buildworld started).
>>
>> With RELENG_7 same hardware works fine.
> 
> Could you please confirm that it's a fresh RELENG_7 (ideally it's
> sync'ed within this month)?

box was reinstalled and upgraded to fresh RELENG_7:

7.1-PRERELEASE FreeBSD 7.1-PRERELEASE #0: Mon Nov 24 21:18:12 MSK 2008

ATA works without problems.

> 
>> From pciconf:
>>
>> atapci4_at_pci0:3:6:0:     class=0x010000 card=0x81501043 chip=0x604111ab
>> rev=0x09 hdr=0x00
>>     vendor     = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
>>     device     = 'MV88SX6041 Marvell Technology Group Ltd. MV88SX6041
>> 4-port SATA II PCI-X Controller (rev 03)'
>>     class      = mass storage
>>     subclass   = SCSI
>>     cap 01[40] = powerspec 2  supports D0 D3  current D0
>>     cap 05[50] = MSI supports 1 message, 64 bit
>>     cap 07[60] = PCI-X 64-bit supports 133MHz, 512 burst read, 4 split
>> transactions
>>
>> From dmesg:
>>
>> ad16: FAILURE - load data
>> ad16: setting up DMA failed
>> ad20: FAILURE - load data
>> ad20: setting up DMA failed
>> GEOM_MIRROR: ad18: FAILURE - load data
>> ad18: setting up DMA failed
>> Request failed (error=5).ad18: FAILURE - load data
>> ad18: setting up DMA failed
>>  ad16s1[WRITE(offset=7948492800, length=131072)]
>> GEOM_MIRRORad16: FAILURE - load data
>> ad16: : setting up DMA failedRequest failed (error=5).
>> ad20: FAILURE - load data
>> ad20: ad20s1[WRITE(offset=7948492800, length=131072)]setting up DMA failed
>> ad16: FAILURE - load data
>> ad16: setting up DMA failed
>> ad16:
>> GEOM_MIRRORFAILURE - load data:
>> ad16: Request failed (error=5).setting up DMA failed
>> ad16: FAILURE - load data
>> ad16: setting up DMA faileda
>> d18s1[WRITE(offset=7948722176, length=131072)]ad16: FAILURE - load data
>> ad16: setting up DMA failed
>> ad20: FAILURE - load data
>> ....
>> ad16: FAILURE - load data
>> ad16: setting up DMA failed
>> ad16: FAILURE - load data
>> ad16: setting up DMA failed
>> GEOM_MIRROR: Device gm0s1: provider ad16s1 disconnected.
>> GEOM_MIRROR: Component ad16cs1 (device gm0s1) broken, skipping.
>> GEOM_MIRROR: Cannot add disk ad16cs1 to gm0s1 (error=22).