On Sun, Jul 27, 2008 at 9:25 PM, Xin LI <delphij_at_delphij.net> wrote: > I have added ICH10 PCI IDs according to Intel's specification. Testing > appreciated. > > If possible please test 6 devices with IDE compatible, AHCI and RAID > modes, thank you! I tested it on G43/ICH10. AHCI and IDE mode work fine. But mine is not ICH10R thus I am unable to test RAID mode. IDE mode: atapci1: <Intel ICH10 SATA300 controller> port 0xac00-0xac07,0xa880-0xa883,0xa800-0xa807,0xa480-0xa483,0xa400-0xa40f,0xa080-0xa08f irq 19 at device 31.2 on pci0 atapci2: <Intel ICH10 SATA300 controller> port 0xbc00-0xbc07,0xb880-0xb883,0xb800-0xb807,0xb480-0xb483,0xb400-0xb40f,0xb080-0xb08f irq 19 at device 31.5 on pci0 AHCI mode is actually ate by ata_ahci_* rather than ata_intel_*: atapci1: <Intel (ID=3a228086) AHCI controller> port 0xb880-0xb887,0xb800-0xb803,0xb480-0xb487,0xb400-0xb403,0xb080-0xb09f mem 0xfe3fa800-0xfe3fafff irq 19 at device 31.2 on pci0 atapci1: Reserved 0x20 bytes for rid 0x20 type 4 at 0xb080 atapci1: Reserved 0x800 bytes for rid 0x24 type 3 at 0xfe3fa800 ioapic0: routing intpin 19 (PCI IRQ 19) to vector 50 atapci1: [MPSAFE] atapci1: [ITHREAD] atapci1: AHCI Version 01.20 controller with 6 ports PM supported Intel has 'corporate' version of ICH10D/ICH10DO, so I updated the patch to add these IDs. Jia-Shiun.
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:35 UTC