Re: PPC Macbook + Firewire

From: Andreas Tobler <andreast-list_at_fgznet.ch>
Date: Wed, 08 Apr 2009 13:41:51 +0200
Horst Günther Burkhardt III wrote:
> On Tue, 2009-04-07 at 22:51 -0700, Sean Bruno wrote:
>> If anyone has the ability to test their PPC Macbook with a Firewire
>> device(external hard disk eg), I'd like to know the results.
>>
>> Please post dmesg output upon connecting the device if you can.
>>
>> Sean
> 
> Hi Sean.
> 
> First, I'm not aware of _any_ MacBook being PPC based, the PPC laptops
> were the iBook and PowerBook, perhaps they are what you refer to?

In case you meant the PowerBook (PPC based), attached a dmesg.

Andreas

Copyright (c) 1992-2009 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.0-CURRENT #3: Sat Feb 21 14:30:20 CET 2009
    andreast_at_wolfram.andreas.nets:/usr/obj/export/devel/fbsd/src/sys/ANDREAST
cpu0: Motorola PowerPC 7447A revision 1.1, 1504.63 MHz
cpu0: L1 I-cache enabled, L1 D-cache enabled
cpu0: 512KB L2 cache
cpu0: HID0 8450c0bc<EMCP,TBEN,NAP,DPM,ICE,DCE,SGE,BTIC,LRSTK,FOLD,BHT>
cpu0: HID1 8000fc80<EMCP,PC1,PC2,PC3,PC4,SYNCBEI,ABE,res>
real memory  = 1063022592 (1013 MB)
avail memory = 1026883584 (979 MB)
nexus0: <Open Firmware Nexus device>
powermac_nvram0: <Apple NVRAM> on nexus0
powermac_nvram0: bank0 generation 432, bank1 generation 431
unin0: <Apple UniNorth System Controller> on nexus0
unin0: Version 210
pcib0: <Apple UniNorth Host-PCI bridge> on nexus0
pci0: <OFW PCI bus> on pcib0
vgapci0: <VGA-compatible display> port 0x400-0x4ff mem 0xb8000000-0xbfffffff,0xb0000000-0xb000ffff irq 48 at device 16.0 on pci0
pcib1: <Apple UniNorth Host-PCI bridge> on nexus0
pci1: <OFW PCI bus> on pcib1
macio0: <Intrepid I/O Controller> mem 0x80000000-0x8007ffff at device 23.0 on pci1
openpic0: <OpenPIC Interrupt Controller> mem 0x40000-0x7ffff on macio0
macgpio0: <MacIO GPIO Controller> mem 0x50-0x7f on macio0
pmuextint0: <Apple PMU99 External Interrupt> extint-gpio 1 irq 47 on macgpio0
scc0: <Zilog Z8530 dual channel SCC> mem 0x13000-0x13fff,0x8400-0x84ff,0x8500-0x85ff,0x8600-0x86ff,0x8700-0x87ff irq 22,5,6,23,7,8 on macio0
scc0: [FILTER]
scc0: [FILTER]
uart0: <z8530, channel A> on scc0
uart0: [FILTER]
uart1: <z8530, channel B> on scc0
uart1: [FILTER]
pmu0: <Apple PMU99 Controller> mem 0x16000-0x17fff irq 25 on macio0
pmu0: [ITHREAD]
adb0: <Apple Desktop Bus> on pmu0
iichb0: <Keywest I2C controller> mem 0x18000-0x18fff irq 26 on macio0
iichb0: [ITHREAD]
iicbus0: <OFW I2C bus> on iichb0
iicbus0: <unknown card> at addr 0x1c0
iicbus0: <unknown card> at addr 0x6a
ata0: <Apple MacIO ATA Controller> mem 0x20000-0x20fff,0x8800-0x88ff irq 24,12 on macio0
ata0: [ITHREAD]
pci1: <network> at device 18.0 (no driver attached)
pci1: <bridge, PCI-CardBus> at device 19.0 (no driver attached)
ohci0: <OHCI (generic) USB controller> mem 0xa0003000-0xa0003fff irq 29 at device 26.0 on pci1
ohci0: [ITHREAD]
usbus0: <OHCI (generic) USB controller> on ohci0
ohci1: <NEC uPD 9210 USB controller> mem 0xa0002000-0xa0002fff irq 63 at device 27.0 on pci1
ohci1: [ITHREAD]
usbus1: <NEC uPD 9210 USB controller> on ohci1
ohci2: <NEC uPD 9210 USB controller> mem 0xa0001000-0xa0001fff irq 63 at device 27.1 on pci1
ohci2: [ITHREAD]
usbus2: <NEC uPD 9210 USB controller> on ohci2
ehci0: <NEC uPD 720100 USB 2.0 controller> mem 0xa0000000-0xa00000ff irq 63 at device 27.2 on pci1
ehci0: [ITHREAD]
usbus3: EHCI version 1.0
usbus3: <NEC uPD 720100 USB 2.0 controller> on ehci0
ohci3: <OHCI (generic) USB controller> irq 0 at device 24.0 on pci1
ohci3: [ITHREAD]
usbus4: <OHCI (generic) USB controller> on ohci3
ohci4: <OHCI (generic) USB controller> irq 0 at device 25.0 on pci1
ohci4: [ITHREAD]
usbus5: <OHCI (generic) USB controller> on ohci4
pcib2: <Apple UniNorth Host-PCI bridge> on nexus0
pci2: <OFW PCI bus> on pcib2
ata1: <Intrepid Kauai ATA Controller> mem 0xf5004000-0xf5007fff irq 39 at device 13.0 on pci2
ata1: [ITHREAD]
fwohci0: <Apple UniNorth> mem 0xf5000000-0xf5000fff irq 40 at device 14.0 on pci2
fwohci0: [ITHREAD]
fwohci0: OHCI version 1.10 (ROM=0)
fwohci0: No. of Isochronous channels is 8.
fwohci0: EUI64 00:0d:93:ff:fe:35:b3:80
fwohci0: invalid speed 7 (fixed to 3).
fwohci0: Phy 1394a available S800, 3 ports.
fwohci0: Link S800, max_rec 4096 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:0d:93:35:b3:80
fwe0: Ethernet address: 02:0d:93:35:b3:80
sbp0: <SBP-2/SCSI over FireWire> on firewire0
fwohci0: Initiate bus reset
fwohci0: fwohci_intr_core: BUS reset
fwohci0: fwohci_intr_core: node_id=0x00000001, SelfID Count=2, CYCLEMASTER mode
gem0: <Apple UniNorth2 GMAC Ethernet> mem 0xf5200000-0xf53fffff irq 41 at device 15.0 on pci2
miibus0: <MII bus> on gem0
e1000phy0: <Marvell 88E1111 Gigabit PHY> PHY 0 on miibus0
e1000phy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX-FDX, auto
gem0: 10kB RX FIFO, 4kB TX FIFO
gem0: Ethernet address: 00:0d:93:35:b3:80
gem0: [ITHREAD]
sc0: <System console> on nexus0
sc0: Unknown <16 virtual consoles, flags=0x300>
Timecounter "decrementer" frequency 18432000 Hz quality 0
Timecounters tick every 10.000 msec
firewire0: 2 nodes, maxhop <= 1 cable IRM irm(1)  (me) 
firewire0: bus manager 1 
usbus0: 12Mbps Full Speed USB v1.0
usbus1: 12Mbps Full Speed USB v1.0
usbus2: 12Mbps Full Speed USB v1.0
ugen0.1: <Apple> at usbus0
ushub0: <Apple OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
ugen1.1: <NEC> at usbus1
ushub1: <NEC OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus1
ugen2.1: <NEC> at usbus2
ushub2: <NEC OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus2
usbus3: 480Mbps High Speed USB v2.0
usbus4: 12Mbps Full Speed USB v1.0
usbus5: 12Mbps Full Speed USB v1.0
ugen3.1: <NEC> at usbus3
ushub3: <NEC EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus3
ugen4.1: <Apple> at usbus4
ushub4: <Apple OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus4
ugen5.1: <Apple> at usbus5
ushub5: <Apple OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus5
firewire0: fw_explore_nodePre 1394a-2000 detected
firewire0: fw_explore_node: fwdev->speed(S400) set lower than binfo->link_spd(S100)
firewire0: New S400 device ID:0001d200005b017a
sbp0: sbp_show_sdev_info: sbp0:0:0: ordered:1 type:0 EUI:0001d200005b017a node:0 speed:2 maxrec:0
sbp0: sbp_show_sdev_info: sbp0:0:0 'Oxford Semiconductor Ltd.   ' 'OXFORD IDE Device LUN 0 ' '000138'
ushub0: 2 ports with 2 removable, self powered
acd0: DVDR <MATSHITACD-RW CW-8123/CA0T> at ata0-master WDMA2
ad0: 76319MB <FUJITSU MHT2080AT 8162> at ata1-master UDMA100
ushub2: 2 ports with 2 removable, self powered
ushub1: 3 ports with 3 removable, self powered
akbd0: <iBook Keyboard> at device 2 on adb0
ams0: <ADB Mouse> at device 3 on adb0
ams0: 4-button 400-dpi Touchpad
ugen0.2: <Apple Computer> at usbus0
ukbd0: <Apple Computer product 0x1000, class 0/0, rev 2.00/15.86, addr 2> on usbus0
ums0: <Apple Computer product 0x1000, class 0/0, rev 2.00/15.86, addr 2> on usbus0
ums0: 5 buttons and [XY] coordinates
Symlink: ums0 -> usb0.2.1.16
ushub4: 2 ports with 2 removable, self powered
ushub5: 2 ports with 2 removable, self powered
ushub3: 5 ports with 5 removable, self powered
da0 at sbp0 bus 0 target 0 lun 0
da0: <Oxford S OXFORD IDE Devic 0138> Fixed Simplified Direct Access SCSI-4 device 
da0: 50.000MB/s transfers
da0: 131071MB (268435455 512 byte sectors: 255H 63S/T 16709C)
Trying to mount root from ufs:/dev/da0s5
gem0: link state changed to UP
gem0: link state changed to DOWN
gem0: link state changed to UP
gem0: link state changed to DOWN
gem0: link state changed to UP
Received on Wed Apr 08 2009 - 09:42:07 UTC

This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:45 UTC