b. f. wrote: > Hmm. From what little I know, your chipset should support AHCI, so > perhaps your motherboard or bios isn't set up right?: > > p. 39, 44 of the pdf at: > > http://www.intel.com/design/chipsets/datashts/307013.htm On page 44 it says, "for some features, hardware support in the SATA device ..." Full output of 'camcontrol identify': pass0: <Hitachi HTS721010G9SA00 MCZOC10H> ATA-7 SATA 1.x device pass0: 100.000MB/s transfers (UDMA5, PIO size 8192bytes) protocol ATA/ATAPI-7 SATA 1.x device model Hitachi HTS721010G9SA00 firmware revision MCZOC10H serial number MPCZN7Y0GZSYAL cylinders 16383 heads 16 sectors/track 63 sector size logical 512, physical 512, offset 0 LBA supported 195371568 sectors LBA48 supported 195371568 sectors PIO supported PIO4 DMA supported WDMA2 UDMA5 overlap not supported Feature Support Enable Value Vendor read ahead yes yes write cache yes yes flush cache yes yes Native Command Queuing (NCQ) yes 31/0x1F Tagged Command Queuing (TCQ) no no 31/0x1F SMART yes yes microcode download yes yes security yes no power management yes yes advanced power management yes yes 16512/0x4080 automatic acoustic management yes yes 254/0xFE 128/0x80 media status notification no no power-up in Standby yes no write-read-verify no no 0/0x0 unload no no free-fall no no Perhaps it does not have the requisite "hardware support" for ahci? -- Improve the effectiveness of your Internet presence with a domain name makeover! http://SupersetSolutions.com/Received on Mon Dec 14 2009 - 06:43:13 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:59 UTC