I have not been able to boot a new kernel since the 14th It stops here: GEOM: new disk ad0 ata1: reiniting channel .. ata1: reset tp1 mask=03 ostat0=00 ostat1=00 ata1: stat0=0x7f err=0x01 lsb=0x7f msb=0x7f ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x00 err=0x01 lsb=0x14 msb=0xeb ata1: reset tp2 stat0=7f stat1=00 devices=0x20001 ata1: Identifying devices: 00020001 ata1: New devices: 00020000 ata1-slave: pio=PIO4 wdma=WDMA2 udma=UDMA66 cable=40 wire Fatal trap 18: integer divide fault while in kernel mode instruction pointer = 0x20:0xc08e825b stack pointer = 0x28:0xc693b754 frame pointer = 0x28:0xc693b7c8 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 12 (swi4: clock) [thread pid 12 tid 100004 ] Stopped at __qdivrem+0x3b: divl %ecx,%eax Before the 14th at the same place: GEOM: new disk ad0 ata1: reiniting channel .. ata1: reset tp1 mask=03 ostat0=00 ostat1=00 ata1: stat0=0x7f err=0x01 lsb=0x7f msb=0x7f ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x00 err=0x01 lsb=0x14 msb=0xeb ata1: reset tp2 stat0=7f stat1=00 devices=0x20001 ata1: reinit done .. ata1: reiniting channel .. ata1: reset tp1 mask=03 ostat0=00 ostat1=00 ata1: stat0=0x7f err=0x01 lsb=0x7f msb=0x7f ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x80 err=0x01 lsb=0x14 msb=0xeb ata1: stat1=0x00 err=0x01 lsb=0x14 msb=0xeb ata1: reset tp2 stat0=7f stat1=00 devices=0x20001 ata1: reinit done .. ata1-slave: pio=PIO4 wdma=WDMA2 udma=UDMA66 cable=40 wire acd0: setting PIO4 on ICH5 chip acd0: setting UDMA66 on ICH5 chip acd0: <ATAPI DVD A DH20A4P/9P57> DVDR drive at ata1 as slave acd0: read 8268KB/s (8268KB/s) write 8268KB/s (8268KB/s), 2048KB buffer, UDMA66 acd0: Reads: CDR, CDRW, CDDA stream, DVDROM, DVDR, DVDRAM, packet acd0: Writes: CDR, CDRW, DVDR, DVDRAM, test write, burnproof acd0: Audio: play, 256 volume levels acd0: Mechanism: ejectable tray, unlocked acd0: Medium: no/blank disc ata2: identify ch->devices=00000000 ata3: identify ch->devices=00000000 pcm0: measured ac97 link rate at 48012 Hz, will use 48000 Hz acd0: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00 (probe15:ata1:0:1:0): error 22 (probe15:ata1:0:1:0): Unretryable Error (probe15:ata1:0:1:0): Down reving Protocol Version from 2 to 0? (probe15:ata1:0:1:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 (probe15:ata1:0:1:0): CAM Status: SCSI Status Error (probe15:ata1:0:1:0): SCSI Status: Check Condition (probe15:ata1:0:1:0): NOT READY asc:3a,0 (probe15:ata1:0:1:0): Medium not present (probe15:ata1:0:1:0): (probe15:ata1:0:1:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 (probe15:ata1:0:1:0): NOT READY asc:3a,0 (probe15:ata1:0:1:0): Medium not present Unretryable error (probe15:ata1:0:1:0): error 6 (probe15:ata1:0:1:0): Unretryable Error pasGEs0 at ata1 bus 0 target 1 lun 0 pass0: <ATAPI DVD A DH20A4P 9P57> Removable CD-ROM SCSI-0 device pass0: 66.000MB/s transfers (cd0:ata1:0:1:0): error 6 (cd0:ata1:0:1:0): Unretryable Error cd0 at ata1 bus 0 target 1 lun 0 cd0: <ATAPI DVD A DH20A4P 9P57> Removable CD-ROM SCSI-0 device cd0: 66.000MB/s transfers cd0: Attempt to query device size failed: NOT READY, Medium not present OM: new disk cd0 scsi_cd.c::ioctl cmd=4400648b error=25 ATA Pseud(cd0:ata1:0:1:0): error 6 (cd0:ata1:0:1:0): Unretryable Error oRAID loaded Trying to mount root from ufs:/dev/ad0s1a ct_to_ts([2009-02-24 18:54:56]) = 1235501696.000000000 start_init: trying /sbin/init ================================== || null_at_pozo.com || || Ph. (415) 681-6235 || ==================================Received on Wed Feb 25 2009 - 02:10:22 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:39:42 UTC